A 1996 Chrysler Town and Country does not have a speedometer or odometer cable. That signal comes from the transmission output speed sensor.
The most common reason for a 1996 Chrysler Cirrus odometer and RPM gauge to stop working is a fuse. If the fuse is removed from the dash and replaced, often times the odometer and RPM gauge will begin working.
There is no valet mode on a 1996 Chrysler Town and Country.
A 1996 Chrysler Town and Country does not have a kill switch.
The fuel injectors are self bleeding on a 1996 Chrysler Town and Country.
A 1996 Chrysler Town and Country has two oxygen sensors. They are screwed into the exhaust on the rear of the engine.
The oxygen sensors on a 1996 Chrysler Town and Country are screwed into the exhaust system behind the engine.
Sounds like the speedometer cable broke.
how to reset the antitheft alarm system in a 1996 Chrysler town&country lxi
No, Chrysler does not use inertia switches.
The spark plug gap on a 1996 Chrysler Town and Country is .050 inch.
There isn't a "cable" like there used to be. The speedometer/odometer is controlled by an eletroic speed sensor. A wiring harness plugs into the back of the dash module containing the speedo.
un-hook the negative battery cable from the battery for 15 minutes and then re-attach cable.
A 1996 Chrysler Town and Country uses DOT3 brake fluid.
According to my Haynes repair manual, 1996 and later models do not use a conventional speedometer cable. They use an electronic speedometer and a vehicle speed sensor (VSS)
You can find a diagram of a cooling system hoses for a 1996 Chrysler Town Country 3.8L in the car's owner's manual. You can also check with auto part stores.
There is no reset on a 1996 Chrysler Sebring.There is no reset on a 1996 Chrysler Sebring.
Chrysler doesn't use inertia switches. The fuel system is computer controlled with relays
It is the silver box next to the battery.
replace them with a better set
Put gas back in it.
The factory system can not be bypassed.