Its located behind the Power Steering pump, tucked in there nicely out of reach.
Add your answer:
Related Questions
Where is the oil sending unit on a 1985 Z24 pickup motor?
by the the oil filter
Where is oil sending unit on a 1985 Ford Thunderbird 3.8L V6?
The oil sending unit is located directly under the oil filter...it has a electrical wire leading to it that you simply remove, then unscrew the sending unit...the reverse to install.
Where is the Oil Pressure Sending Unit located on a 1990 Ford F-150 with a 302 motor?
The oil pressure sending unit on a 302 ford is located on the block of the engine. It screws into the block and the sending unit goes on the end. The oil pressure sending unit on a 302 Ford is slightly above and to the left of the oil filter. I find it is easier to replace with the oil filter out.
Where is the oil pressure sending unit located on a 1995 ford f150 wiith a 302 motor?
Its located in front of the oilfilter on left side of engine
Where is the oil sending unit on a 1985 ranger 2.8?
Where is the oil sending unit on a 2.8
Where oil sending unit on 1992 Ford Ranger?
Where is the oil pressure sending unit on 1992 ford ranger
Where is oil sending unit on a 2004 ford free-star?
Where is the oil sending unit on ford freestar
How do you change the sending unit on a 1991 4 cylinder ford ranger?
Do you mean the Temp sending unit, oil pressure sending unit, or fuel level sending unit?
Where is the oil pressure sending unit on a 1986 ford f250 with a 6.9l diesel motor?
Look at the top of the engine at the rear center
Where is the oil sending unit on 1999 ford ranger 4.0 motor?
The sending unit for the oil pressure guage on a 4.0 L OHV engine is on the driver's side of the engine below the power steering pump - Helpfull
Where is the oil sending unit on a 1991 Ford F250?
wher is the oil sending unit for a 1999 ford f250 v10 triten located on moter
What is a sending unit on 1986 ford pickups?
Any sensor that sends information to the computer or driver, such as fuel sending unit, oil pressure sending unit, etc.
Where is the temperature sending unit on a Ford V-10 gas 6.8L Is it a true sending unit or just an on-off switch?
The temperature sending unit on a Ford V10 gas 6.8 liter is on the front of the cylinder head. It is a true sending unit and not just an on and off switch.
Where is oil sending unit located on 1997 Ford Taurus?
For the DOHC motor look behind the dipstick tube for a single wire sensor.
Where is the coolant temp sending unit on a 2001 ford expedition?
Temperature Gauge Sending Unit The sending unit is located in the front section of the intake manifold in the vicinity of the thermostat.
Where is the oil pressure switch located on 1997 Ford F250 with 460 motor?
The oil pressure sending unit is on the back of the block just above the bell housing. The unit screws in.
Why dont fuel gauge work on 1985 Ford F-250?
It could be your fuel gauge or your sending unit or the wires connecting them . If you have dual tanks it could be the switch that changes tanks. The most likely culprit is the sending unit in the tank.
Where is the temperature sending unit located on a 1990 ford f-150 350 cu in?
fords don't have a 350 the 350 is a Chevy motor
Where is water sending unit located on a Ford F-250 460 gas motor?
Should be on the intake driver side toward the front
What causes an 05 Ford F150 XL 4.2 motor to show hot but vehicle is not running hot?
Could be a faulty temp sending unit.
Where is the ford ranger xlt 6cyl 3.0l temp sending unit located?
where is the temp. sending unit located on a 1999 ford ranger xlt 6cyl 3.0l .Gauge does not work.
Where is the oil pressure sending unit on a 1995 Beretta?
What size motor?
Where is the oil sending unit located on a 2001 Chevy truck 2500?
The oill sending unit is almost always on the back of the motor by the fire wall.
Where is the temperature-sending unit for a 1999 Ford Taurus?
The temperature sending unit on the 1999 Ford Taurus v6 is on the rear of the engine. It is closer to the driver side about 7 inches down.
Where is the oil sending unit for 1989 f-150 ford?
the oil sending unit its right next to the dipstick and the oil filter on the ford 300 its a screw in device with a wire protruding from it.
