answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered 2006-09-12 00:44:00

Do you not have an owners manual? It uses a cartridge type oil filter. This is where a reusable housing is used and you only change the paper-filtering medium inside. These are usually sold as GMC oil filter kits where you get the paper filter oil filtering material and the associated rubber O-rings that seal the paper inside the housing. Go buy the filter and it will come with instructions for installation. The filter is located on top of the engine.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Your Answer

Related Questions


"Where is the fuel filter located on a 2001 Chevrolet Malibu?"


The 2006 six-cylinder Chevrolet Malibu oil filter is located on the rice side of the engine, near the bottom. The oil filter can be best viewed from beneath the engines.



It is located under the car on the inside of the frame near the gas tank.


were is the oil filter located on a 1960 Chevrolet impala 6 cylinder engine located


The fuel filter is located under the rear of the car, rearward of the fuel tank.


The 2006 Chevy Malibu does not have an accessible fuel filter. There is a filter within the tank that should only be serviced at a Chevrolet service center.


it is between the gas tank and the muffler, you have to jack the car up to get to it


Where is the fuel filter located on a 1998 Chevy Malibu?"




Probably under the vehicle- follow the fuel line from the tank


per the owners manual there is no cabin filter.


I have a Chevy 2004 Colorado V3500 5 cylinder engine. Filter is on the passenger side at the front of the engine. Easy to get too.


where is the oil filter located on a 2009 chevy malibu?


Where is the fuel filter located on a 1990 chevrolet blazer?


The fuel filter is located on the driver's side frame just forward of the gas tank. It requires a special tool to release the fuel line from the filter.


The gas filter on 2001 Malibu is where the gas filter for any of the cars would be located at. It is located next to the gas tank and can be changed easily.


On V6 models, the knock sensor is located on the front (radiator) side of the engine block above the oil filter.


You need to look on the drivers side from the top. There is a a Black 32mm cap that will need to be unscrewed and the oil filter is in there.


on 4 cylinder models,the knock sensor is located on the rear (firewall) side of the engine block below the exhaust manifold..on v6 it is in front (radiater) side of the engine block above the oil filter!!


The oil filter is located on the top side. Open the hood and look on the left side of the engine (your right)and you will see a round silver looking cylinder with a black cap with a nut shape on the cap. The filter is an insert. Unscrew the cap and the filter will lift right out.






Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.