answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered 2006-11-01 23:08:27

The oil pressure sending unit is located on top of the motor beside the base of the distributor. You will need a special socket from your parts store to remove/install the sending unit without harming the new one. The socket is not expensive and does fit sending units for other cars.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Your Answer

Related Questions


Chrysler Fifth Avenue was created in 1982.


The answer can be found at www.dippy.org. I just did this last week


There is no such thing as a 1998 Chrysler Fifth Avenue


There is no such thing as a 1998 Chrysler Fifth Avenue


There is no such thing as a 1998 Chrysler Fifth Avenue



There is no such thing as a 1998 Chrysler Fifth Avenue


No you don't but if you are putting a different carb on you might have to change the manifold.


U-joints. Get a hammer and a punch. Replace both ends of the drive shaft.


The firing order for a 1985 Chrysler Fifth Avenue with a 318 c.i. engine is 18436572.


you will have to take all the panels out to back and pull up the cardboard and there are the speakers


Chrysler does not use inertia/reset switches.


replace fuel pump. its on the pass side under the alt. or power steering pump on v-8 engines.



The title Fifth Avenue refers to a street in New York, United States. Fifth Avenue contains many upscale shops and cultural attractions.The name first appeared as a special, upmarket sub-model of the R-body Chrysler New Yorker sedan.





In the exhaust manifold on the back of the engine.



The fuel pump on a Chrysler Fifth Avenue can be removed by lowering the fuel tank, disconnecting the fuel lines, and pulling the pump from the tank. This wiring harness can then be disconnected from the pump before it is removed.


I would say the biggest size rims you should put on a 1994 Chrysler Fifth Avenue or a New Yorker would be 20 inch rims.


The fuel filter on a 1985 Chrysler 5th avenue should be below the alternator on the passenger side of the car


The question you ask is too involved for a proper answer. You need to go to a car parts store, and get a repair manual for your car. They cost about $16.00 Or, go to a Public Library.




Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.