its where the sending unit is on every combustion engine ever built: right at the discharge of the oil pump, which is also where the oil filter is located. look right above it. it is not necessaraly right by or above the oil filter. If it is a 4.0l V-6, it is located on the drivers side of the engine block, a little lower than the spark plugs, and is the only part on that part of the block that has a wire running to it.
Where is the oil pressure sending unit on 1992 ford ranger
On the ( 4.0 liter EFI , V6 engine ) in a 1996 Ford Ranger : The oil pressure sending unit is on the drivers side of the engine , below the power steering pump
located below the oil filter
Do you mean the Temp sending unit, oil pressure sending unit, or fuel level sending unit?
Bad oil pressure sending unit?
My Ford Ranger is a 1998 4.0 ltr V6.
What is the timing for a 1998 ford ranger 2.5l
The oil pressure sending unit is on the drivers side of the engine below the power steering pump on the 4.0 liter V6 in a 1997 Ford Ranger
yes it has both. at least in my 1991 ford ranger does
the oil pressure sending unit is designed to warn you of a low oil pressure. If the sensor goes bad then the low pressure light or gauge will read low when the oil pressure is actually ok.
No, the cab was lengthened in the 1998 model year.
what is the axle gear ratio for a 1998 ford ranger 4x4 4.0l?