On the passenger side of the engine block near the oil filter. If you have th 4.7 Liter V-8 the oil pressure sending unit is directly above the oil filter on the driver's side. To be able to easily remove the connector, remove the oil filter , On the connector slide the red tab sideways, push down on the plastic tail on the rear of the connector and slide it back. Use a 1 and 1/16 inch DEEP socket to remove the sensor or if you have to, a wrench. You can do this without removing the filter but you will need to remove the connector blindly.
above the starter
The oil pressure sending unit on a 1999 inline six cylinder is located on the engine block very close to the oil filter. It is constructed of plastic and metal, screws into the block and has a two wire lead plugged into it.
Not too difficult... That is, if you can find it. I have a '96 JEEP GC Ltd & my oil pressure sending unit was located at the back of the intake manifold by the distributor cap. !!!Pain in the Ass!!!
A seat from a 1999-2004 Grand Cherokee is what fits in a 1999-2004 Grand Cherokee.
Bad sending unit in tank.
I use Havoline 5W-30 in my 1999 Grand Cherokee.
where is the ac drain on 1999 jeep grand cherokee limited
Inside the transmissison, on the valve body.
Replace oil sending unit with a manual gauge
I get 15 to 17 miles per gallon with my 1999 Jeep Grand Cherokee Lorado.
No, they will not interchange.
No. They are not interchangeable.
No. Different shape.
The temperature sending unit on a 1999 Jeep Cherokee 4 liter is screwed into the thermostat housing on the front of the engine.
Check sending unit or sending unit wiring for short to ground. Also could be a plugged oil line causing a spike in pressure. Try installing a mechanical gauge to get an accurate pressure reading.
If same engine, yes.
Regular unleaded is the recommended fuel for a 1999 Jeep Grand Cherokee.
New lifters or repairing the cause of low oil pressure.
The junction box in a 1999 Jeep Grand Cherokee is on the passenger side. It is located on the front side kick panel.
Trouble code P1494 means: Leak detection pump pressure switch or mechanical fault