it is behind the destribuater at the firewall
knock sensor
low pressure on you MAP sensor clean it or replace it
No. A Chevy Blazer does not have a reset switch.
Not unless the 1992 is 4x4.
The ECM on a 1992 S10 Blazer is located below the glove box.
It is screwed into the passenger side of the engine block just in front of the starter.
1992 Chevy trucks did not have a CAM SENSOR. They had a distributor.
Put your new fan belt around the pulleys of your 1992 Chevy Blazer. Tighten the fan belt with the tensioner pulley.
It does not have a crank sensor.
The 1992 did not use a crankshaft sensor.
Mine has 320,000
Inside the fuel tank.