answersLogoWhite
Car Computers and Sensors
Oil and Oil Filters
Chrysler Cirrus
Dodge Charger
Grand Am SE

Where is the oil pressure sensor on a 1998 Chrysler Cirrus 2.5l V6?


Top Answer
User Avatar
Wiki User
Answered 2007-04-14 15:13:52

The oil pressure sensor is on the oil filter housing just above the oil filter. It is about 1 1/2 inches long and points tword the front of the vehicle. It has a electrical connector plugged into the front of it. You have to take off the oil filter to get to it.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Your Answer

Loading...

Still Have Questions?

Related Questions

Is there adjustment on the throttle position sensor on a 1998 Chrysler cirrus 2.5?

No.No.


Where is the fuel level sensor in a 1998 Chrysler Cirrus?

The fuel level sensor is on the fuel pump module in the tank.


Can you test a mass air flow sensor on a 1998 Chrysler cirrus 2.5?

It does not have a mass airflow sensor.It does not have a mass airflow sensor.


How do you adjust lifters on 1998 cirrus?

The hydraulic lifters on a 1998 Chrysler Cirrus are not adjustable.


Will a transmission pan from a 1998 Chrysler cirrus fit on a 2000 Chrysler cirrus?

check the size of the engine, if it is the same it will fit


Is there a reset button on a 1998 chrysler cirrus lxi?

NoNo


Where is the fuel pressure regulator on a 1998 Chrysler cirrus?

It is part of the fuel pump module. It is located inside the fuel tank.


What kind of oil does a 1998 Chrysler Cirrus use?

5w30


Does a 1998 Chrysler cirrus need timing belt?

Yes


Can you change the crankshaft sensor without having to change the whole distributor on a 1998 Chrysler cirrus?

The crank sensor is not in the distributor, it is in the top of the bell housing. The cam position sensor is in the distributor and is not available separately


What is the size of a 1998 Chrysler Cirrus gas tank?

16 gallons


What is the firing order for 1998 Chrysler cirrus v6 with a distrubitor?

1,2,3,4,5,6


What kind of rear brakes does a 1998 Chrysler cirrus have?

drum brakes


Where is the fuel pump on a 1998 Chrysler cirrus?

It is inside the fuel tank.


Does a 1998 Chrysler cirrus have a fuel shut off switch and where is it?

No, Chrysler does not use inertia or reset switches.


Where is the inertia shut off switch on a 1998 Chrysler cirrus?

Chrysler does not use inertia/ reset switches.


Where is the oil sensor on a 1998 Chrysler Town and Country 3.8?

The oil pressure sensor is on the front of the engine, just to the side of the oil filter.


How much engine oil does a 1998 Chrysler cirrus hold?

4.5 quarts


Do the coils in a 1998 Chrysler cirrus go bad?

Yes, they can.Yes, they can.


Is a 1998 Chrysler cirrus a interference or non-interference engine?

Interference.


How do you adjust the idle speed on a 1998 Chrysler cirrus?

Idle speed on a 1998 Chrysler is computer controlled and is not adjustable. If idle speed is incorrect, you have a sensor, actuator, or mechanical failure. Places to start are, check for engine fault codes. Check for vacuum leaks.


Is there a special wrench used to remove the oil pressure switch on a 1998 Chrysler Town and country Van?

It is called an oil pressure sensor socket.


Where is the starter on a 1998 Chrysler Cirrus?

It is behind the engine mount on the radiator side of the engine.


How many quarts of oil are used in a 1998 Chrysler cirrus?

Engine holds 4.5


Where is fuel pump in Chrysler cirrus 1998?

in the gas tank, you will have to drop it down to change it.