It's on the lower right side of the engine above the transaxle.
I'm a retired ASE Master/L-1 Technician. I still keep current with the latest automotive technology. Visit my blog for cool articles and TSB's: http://free-auto-repair-advice.blogspot.com
The oxygen sensor on a 1999 Oldsmobile Intrigue 3.3 liter is in the exhaust manifold/pipes
I have a 1999 Oldsmobile Intrigue 3.5 liter, I will like to know were the Timing chain marks.
Can you show me a diagram of the upstream oxygen sensor on a 3.5l liter Oldsmobile Intrigue engine?
The fuel pressure of a 1999 Oldsmobile 3.8 liter V6 is 35 psi. A fuel pressure gauge is needed to measure the fuel pressure.
The 3.5 Liter motor was optional in 1999. From 2000-2002 the only motor offered was the 3.5 L.
You need to replace the entire assembly . done mine 2 ours joe
The 1997 Pontiac Trans Am 5.7 liter engine oil pressure switch can be found on top of the engine. The oil pressure switch will be near the intake manifold.
The 2001 General Motors (Oldsmobile Division) Intrigue came equipped with the 3.5L engine and 4-speed automatic transmission FWD. One method of purging air from the cooling system after repairs and flushing it involves refilling it, and running the motor and heater, and leaving the radiator pressure cap off to 'burp' off the air trapped inside.
beneath a plate that's bolted on,first thing you see when standing in front of car looking at engine
On the 5.4 liter the pressure switch is on the Oil filter housing.
A Buick with a 3.8 liter engine does not have an oil pressure switch. There is an oil pressure gauge. The gauge can be accessed by removing the dashboard panel. Unhook the wiring harness to the gauge. Reverse the process to replace the gauge.
To unplug the oil pressure switch for a 1999 Chrysler Sebring 2.5, simply remove the connector from the back of the switch. With the switch unplugged, the computer will think the engine has low oil pressure.
There are no timing belts on any of the Intrigues. both the 3.8 and the 3.5 liter engines have timing chains. The 3.8 has 1 chain and the 3.5 has 3 chains.
There is no relay, only a pressure switch that is wired directly to the instrument cluster with no relay in between. The pressure switch is located right next to the oil filter on a 4.6 or a 5.4 liter, and it is sticking out of the driver's side of the timing cover on a 4.2 liter.
A 3.8 of the same series from any GM Division. 3.4 do not share the same bolt pattern. 3.5 Intrigue engines are only in certain Intrigues and Auroras, and do not share the bolt battern with 3.8s. But this comes from someone who has put a 455 Toro in the rear of an S10, and a W-41 in a Fiero. Anything goes in anything if you are creative. :)
what are the head tourque specs for a 1986 Oldsmobile calais 2.5 liter ?
I can't seem to find it either.
There is no such thing as an oil pressure switch on your 1994 Ford Ranger 3.0 liter engine. There is an oil pressure sensor. The oil pressure sensor can be found on the left-hand side of the engine.
The 1997 Chevy Lumina 3.1 liter low pressure air conditioning cycling switch can be found on the air conditioning compressor. The switch will be on the top of the compressor.
fuel pump is in the tank, and the oil pressure sender switch is located on the driver side of the motor just to the right of the distributor.
NO.. It will not.
that would be 5.7 Liter
it is in the side of the oil pan