0
It is on the back of the motor under the intake.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Oil pressure is reading high on corvette but oil is at correct level. Does this indicate a bad sensor switch?
High oil pressure is good....
Where is the oil pressure switch on a 2000 Honda civic si?
The oil pressure switch on a 2000 Honda Civic is on the top of the motor. It screws in the side of the vtec solenoid.
Do you have to drain the oil to replace oil pressure switch on 2000 Chrysler 300m?
No
Where is the Oil pressure switch 2000 Honda crv?
driver left of the oil filter on a 2000 crv
What is normal oil pressure for 1987 Corvette?
what is the normal oil pressure on a 1987 corvette when standing still
Where is the oil pressure switch located on the engine on a 1998 corvette?
IT IS LOCATED IN THE REAR OF THE INTAKE... YOU HAVE TO REMOVE THE INTAKE TO CHANGE IT....
How do you check if the low pressure switch on a corvette 1977 is working?
Of which low pressure switch are you speaking? Engine oil pressure switch? If you're checking that, remove the oil pressure sending unit and temporarily put in an oil pressure gauge. If you're checking the AC low pressure switch, pull the switch from the AC low pressure line, Jumper the switch socket and see if the AC compressor comes on. If it does, you either have low refrigerant pressure or a bad switch. If you KNOW the pressure is up and everything else works, you have a bad switch.
What is the correct oil pressure for a 1987 corvette?
The 1987 Chevrolet Corvette oil pressure should be between 45 PSI and 40 PSI. The idling oil pressure will be slightly less.
On a 1994 corvette where is the oil temperature switch located at?
== ==
How do you Change oil sensor switch 2000 dodge intrepid?
how to change oil pressure switch in 2001 Dodge Intrepid I need to look at a diagram
How do you install a oil Pressure switch on a 2004 corvette z06?
There is a great diagram in the C5 section at Smokinvette.com. Ask for "corvettedon" and good luck!
Does a oil pressure switch monitor the oil level?
A pressure switch reads pressure not level.
