The orifice tube is located in the high pressure line at the left-bottom of the condensor (which mounts in front of the radiator). Where the line exits at the left-bottom (this is driver's side) of the condensor you will find an inline connector. Above this connector you will notice three small dimples in the line - this is where the orifice tube is mounted. Break the line (carefully!) and remove the orifice tube with a pair of needle nose pliers. Begin removal by gently twisting the orifice tube to break its seal and extract. Be careful because these can be broken easily and any remaining portion in the line is of course more difficult to extract. Also, the line and its connector is aluminum. Typically the threads are very dry and extremely difficult to break loose. You MUST use a backup wrench along with the one used to loosen the connector and it will help by using some type of penetraing oil/lubricant. Be careful with this as it is easy to either twist the line itself (and ruin it) or pull the threads off the aluminum nut at the connection.
where is the knock sensor located on 93 cutlass ciera
Where is the signal flasher located on a 1987 Oldsmobile Cutlass Ciera?
Sometimes the flasher relay on a 1992 Oldsmobile Cutlass Ciera is located in the fuse box. Other times it may be located under the dash near the steering column.
The starter on a 1994 Oldsmobile Cutlass Ciera is located on the driver's side of the engine towards the bottom of the engine. It is behind the crankshaft sensor and the fusible links.
The door lock/unlock relay is located behind the I/P on a 1995 Oldsmobile Cutlass Ciera. The relay is at the RH shroud just beside the center access hole
It should Be located on the top of the transmission.
How do you change the heater core on a 1989 Oldsmobile Cutlass Ciera? or where can I get the Info on replaceing it
what is the oxygen sensor location on a 1993 oldsmobile cutlass ciera 3.3l v6
The 1994 Oldsmobile Cutlass cam sensor is located on the back of the left cylinder head. The cam sensor should be labeled as such.
The 1993 Oldsmobile Cutlass Sierra thermostat is located on the front of the engine. You can follow the water supply line from the radiator to the thermostat housing.
where is the crank sensor located at on a 1996 cutlass ciera wit a 3.1 engine
where is the horn relay
What would make a 1899 oldsmobile cutlass ciera start and then die right away?
The Oldsmobile Cutlass Cierra window lift motor is located inside of the door. Each window is equipped with a window lift motor.
Its located on the bottom of the throttle body right next to the fuel pressure valve.
The Kelley Blue book on a 1992 Oldsmobile Cutlass Ciera ranges from $1825 - $2175.
no it has dic brakes
its located on the lower left side of the condenser ,, drivers side. its in the tube with the brass connecter nut ,... if you seperate the connector you can look up into the top tube and pull it out with needle nose pliers.... yes
if its like my 87 olds ciera 4cyl its attached behind the ignition moduallType your answer here...
Where is the choke sensor on a 1991 Oldsmobile ciera 3.3L
where is cam senor on a 91 cutlass ciera 3300
wher is the TPS located on a 96 oldsmobile ciera 3.1L ?
On the front of the engine.
It has ABS.