Oxygen Sensors
Nissan Maxima
Ford Windstar LX
1995-2005 Chevy Cavaliers

Where is the oxygen sensor located and how do you replace it on a 1992 Maxima SE?

838485

Top Answer
User Avatar
Wiki User
2005-09-10 21:12:09
2005-09-10 21:12:09

look at the exhaust pipe between the motor and the catalytic converter(underneath the car, about where the center console sits). It faces the passenger side and it's wire runs to a connector somewhere under the windshield wiper motor.(passenger side firewall)

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Did you figure out where this sensor is located

User Avatar

The upstream oxygen sensor is located in the exhaust pipe between the exhaust manifold and the catalytic converter The downstream oxygen sensor is located at the catalytic converter outlet

User Avatar

There are 4 oxygen sensor on Maxima 1997. 1.- Fronto Sensor Driver Side 2.- Front Sensor Passenger Side. 3.- Two rear sensors: first one located on Catalytic Converter and other one after it.

User Avatar

Check this site out, it shows you. http://www.nissanhelp.com/diy/maxima/projects/nissan_maxima_o2_sensor_identification.htm

User Avatar

The O2 sensor is located on the exhaust system there might be more then one

User Avatar

There are four oxygen sensor in a Maxima 2001. See Nissanhelp.com for a diagram location.

User Avatar

in the exhaust manifold. is there any place to buy a used one?

User Avatar

On a 2005 Nissan Maxima where is the Camshaft Position Sensor (Bank 1) located?

User Avatar

where is the camshaft sensor in a 96 nissan maxima 3.0

User Avatar

the knock sensor is located under the intake manifold, with a flash light you can see it however you have to remove the intake manifold to replace the knock sensor , also you will need to replace the intake gasket set as well!

User Avatar

can you tell me were the map sensor

User Avatar

The knock sensor is located below the intake manifold

User Avatar

The knock sensor is located below the intake manifold

User Avatar

bank 2 is on the left side of the engine or the side closest to the front of the vehicle. So the oxygen sensor would be on the exhaust coming from the left side.

User Avatar

THE O2 SENSOR IS LOCATED ON THE MANIFOLD. IT JUST UNSCREWS OFF THE SIDE OF IT, THEN YOU JUST UNPLUG IT.

User Avatar

To replace the oxygen sensor on a Honda Odyssey, first unscrew the sensor. Then use a 22 mm socket or 7/8 inch wrench to replace the oxygen sensor.

User Avatar

The knock sensor is located on below the intake manifold on a 1999 Maxima

User Avatar

Answer I found this great site about Nissan O2 and its location to fix with diagrams!

User Avatar

unplug the connector, remove the oxygen sensor, it is located under the vehicle at the catalytic converter. install new oxygen sensor, plug in connector. done.

User Avatar

Oxygen sensor is located at the exhuast Manifold.

User Avatar

The knock sensor is located below the intake manifold

User Avatar

the Knock sensor is located behind the Harmonic balancer pulley. on the bottom sidethe sensor is $95.00 remove the lock down screw unplug and replace

User Avatar

The 2002 VW oxygen sensor is quite simple to replace. Remove the wiring harness. The oxygen sensor will simply pull out.

User Avatar

The front oxygen sensor is located on the exhaust manifold of the BMW 318ti. The rear oxygen sensor is located in the head pipe.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.