Leaderboard
Wiki User
Answered 2005-05-19 06:05:50
In the exhaust pipe. the oxygen sensor is not in the exhaust pipe it is directly under the hood off of the exhaust manifold. it sets by itself and is easy to get to. you will probably have to cut the old sensor wire to get the old one out.
Your Answer
Related Questions
Where is the wiper motors in a 92 mercury Capri?
Look at the center section of the firewall
What front end parts are compatible with the 92 mercury capri?
Ford Mustang
Where is fuel pump relay located in a 92 Mercury Capri?
The fuel pump relay is locate under the ECM. "Computer"
Where is the oxygen sensor located on 92 Geo storm?
Check the exhaust manifold.
Where is the oxygen sensor located in a 92 ford f250?
On the exhaust pipe between the engine and the catalytic converter
Where is the throutle sensor on a 92 Pontiac transport?
throttle sensor for a 92 pontiac transport
Where is the 92 Cadillac deVille oxygen sensor?
check on the back side of the engine by looking underneath the car, you should see it there
Where is the LAF sensor located on a 92 Honda Civic?
Where is the LAF sensor located on a 92 honda civic?
Where is the crankshaft position sensor on 92 Toyota?
the 92 4afe toyota engine does not have a crankshaft position sensor
Where do i find the oxygen sensor on a 92' dodge ramcharger 4x4?
look on the Y pipe on the exhaust right under the manifold
Where is the oxygen sensor on a 92 Chevy Lumina?
Most oxygen sensors are either on the exaust headpipe just after the manifold or on the manifold. I don't know where it is exactly on the Lumina but that is where you should start looking.
If oxygen Saturation is 92 do you give oxygen?
yes
How do you replace the oxygen sensor on a 1999 Ford Expedition 4.6L?
LOCATE THE SENSOR IN QUESTION THEN WARM THE ENGINE SLIGHTLY TO MAKE REMOVAL OF THE 92 SENSOR EASIER THEN USING A 02 SOCKET OR 7/8 WRENCH LOOSEN THE 02 SENSOR AND REMOVE IT ALSO DISCONNECT THE WIRING CONNECTOR.
Why is your heater not working on 92 Mercury Capri?
me heater has been acting up in the extreme cold lately and i have to "jump start it lol" by turning it on then flipping the indoor outdoor control a few times and then it kicks in... i assume the flap is messed up
Location of 2 sensors on the exhaust on a 1992 Saturn?
There is only one oxygen sensor on '92 Saturns and it is located on the exhaust manifold right under the hood.
Where is the cram sensor?
para lumina 92
The passenger side lite on your 1991 mercury capri will not come up drivers side is fine can you put it up manually?
On my 92 you can manually put eather headlight up.There is a knob behind each light Just turn knob clockwise.
Where is the barometric pressure sensor on a 92 eclipse?
The MAP sensor is located on intake manifold.
Where is the crank sensor located on a 92 Ford Tempo?
The 92 tempo doesn't have a crankshaft sensor. However the multi-port fuel injected models do have a Camshaft Position Sensor located near the distributor.
You put a new crank sensor in your 92 Buick and now its like its out of time?
You put a new crank sensor in your 92 buick and now its like its out of time?
What would cause a 92 geo storm to run very rich?
air filter, oxygen sensor, sticking injector, plugs, EGR valve... What does the computer say?
Where is the crank angle sensor on a 92 eclipse?
the cam angle sensor is the crank angle sensor it preforms both jobs
Will 92 park avenue start with bad cam sensor?
No it will not start need to change the cam sensor & crank sensor!
Where is the oxygen sensor on a Chevy G 20?
The O2 Sensor on my 92 G20 with a 4.3L is on the left header tube on the top, right next to the transmission. its a 3 wire 02 Sensor....hope this help, I just need to know what size open ended wrench to use...i think its a 16mm
How many O2 sensors are on a 92 Chevy C1500 with a V6 4.3L engine and where are the O2 sensors located.?
Single exhaust? Look before and after the converter. O2 sensors measure oxygen content before and after flow through the converter.answerThe oxygen sensor is a spark plug shaped device that is screwed into the exhaust manifold. Answer:There is one sensor located before the cat convertor. It will be a 3 wire sensor.
