Oxygen Sensors
Ford Ranger
Chevy Silverado
Mitsubishi Outlander

Where is the oxygen sensor on a 1991 ford ranger 3 liter v6?

192021

Top Answer
User Avatar
Wiki User
2006-01-24 09:59:44
2006-01-24 09:59:44

the o2 sensor is located on the exaust manifold

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

motorcraft . com just shows ( 1 ) oxygen sensor for all available engines in a 1991 Ford Ranger

User Avatar

If it's like a 1991 Ford Explorer ( with the 4.0 liter V6 engine ) It has ( 1 ) oxygen sensor

User Avatar

Looking at the 1991 Ford Ranger - 4.0 L V6 - engine wiring schematic in my Chilton repair manual , it shows ( ONE ) heated exhaust gas oxygen sensor

User Avatar

In a 1991 Ford Ranger : The heads on the 2.9 , 3.0 and 4.0 liter V6 engines are cast iron

User Avatar

It has ( one oxygen sensor ) on the 1991 and 1992 Ford Explorers

User Avatar

yes it has both. at least in my 1991 ford ranger does

User Avatar

I'm taking a guess here that it possibly has 1 - the 1991 and 1992 Ford Explorers with the 4.0 L OHV engine only have 1 oxygen sensor

User Avatar

they are located on the exhaust manifolds

User Avatar

The oxygen sensor is located on your lower exaust pipe just before the cat underneath the car

User Avatar

The 1991 Cadillac Deville oxygen sensors are located on the firewall and the air cleaner housing. The firewall oxygen sensor will be on the drivers side. The air cleaner oxygen sensor will be on the back of the air cleaner housing.

User Avatar

If your looking for the oil level sensor it would be located on the driver side on the oil pan.

User Avatar

The crankshaft sensor shold be on the engine block about midway on the back side.

User Avatar

If you mean ignition timing it will be 10 degrees BTC.

User Avatar

I don't know if it is the same as the Ford Mustang , but the BAP sensor was mounted on the firewall - good luck

User Avatar

oxygen sensor is found on y pipe under the exhaust manifold on 4 point zero six v engines

User Avatar

they are located right at the exhaust manifold

User Avatar

It threads into the exhaust manifold on the back of the engine.

User Avatar

The 1991 Pontiac Grand Prix oxygen sensor is located on the outside of the air filter housing. You will find the sensor on the back side of the air filter housing.

User Avatar

Gas sensor? Not sure what you mean, could it be a Fuel gauge sensor? Oxygen sensor? Fuel pressure regulator?

User Avatar

On the 4.0 liter OHV it's on the drivers side of the engine , low down , where the transmission is bolted to the engine

User Avatar

It depends on the engine that you have. Here's a list of the HP ratings for 89-92 Ranger engines. 2.3 liter 4-cylinder: 98 hp 2.9 liter Cologne V6: 140 hp 3.0 liter Vulcan V6 (introduced for 1991): 145 hp 4.0 liter Cologne V6: 160 hp

User Avatar

After you open the hood, look straight down and it will be a stainless steel cylindrical wired sensor coming out of the exhaust manifold.

User Avatar

It is located on the bell housing on the driver's side of the vehicle.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.