Most of the time and O2 sensor is on the exuast pipe somewhere sometimes it is up near the engine or sometimes it is near the back or both depends on the car dont know the exact locations hope it helps The o2 sensor is mounted on the exhaust pipe. You can get to it by removing the air filter housing. Look down into the open area and you should see the sensor mounted on top of the pipe between the engine and the fire wall.
It is screwed into the exhaust behind the engine.
It is in the exhaust manifold on the back of the engine.
There are two screwed into the exhaust on the rear of the engine.
The 2000 Plymouth Voyager had three engine options for that year, the 2.4L, 3.0L, 3.3L engines. If your vehicle was equipped with the Flex Fuel system or (TLEV) Transitional Low Emission Vehicle, it wouldn't make a difference. The Plymouth Voyager was only equipped with two oxygen sensors, one usually located up at the engine and one usually located down on the exhaust after the catalytic converter.
Between $40 - $60 seems typical. The actual cost will depend on specifics of your vehicle, such as which engine it has.
Back of engine. One is in exhaust manifold, the other is screwed on behind hte catalytic converter.
in the exhaust manifold right before the flex pipe. in the 3.0 it is located behind the engine.
It is in the exhaust manifold next to the firewall.
they have 2 o2 sensors on the muffler ELIA
behind the motor, on top of the exhaust.
There are two, one on each side of the catalytic converter in the exhaust pipe.
On a 3.3 or 3.8 you may have to remove the wiper cowling to access.
should be right above the catalytic converter, on the exhaust manifold
There are two, one on each side of the catalytic converter.
o2s signal stays below center (lean) oxygen sensor signal input indicates lean air/fuel ratio condition during engine operation
It is screwed into the exhaust manifold on the rear of the engine.
Hey Mario==It will be close to the exhaust flange and on some cars it is in the exhaust manifold. GoodluckJoe
If you have a 4 cylinder engine, you will have two. On a 6 cylinder, you will have four.
the oxygen sensor in located in the exhaust manifold under the intake manifold at the back of the engine
It depends on number of cylinders the engine has. 4 cylinder engine has 2 oxygen sensors. V6 has at least 3.
O2 sensor in the exhaust manifold near the engine
Sensor one is in the exhaust manifold on the back of the engine. Sensor two is in the side of the catalytic converter.