The 1999 Dodge Stratus PCM valve can be found on the outside of the air cleaner housing. The PCM valve is located on the back of the housing.
THE COMPUTER ON A 97 DODGE STRATUS IS A PCM IT IS LOCATED BESIDE THE POWER DISTRIBUTION CENTER UNDERNEATH THE HOOD BY THE AIR CLEANER IT IS LIKE YOUR CARS BRAIN
No, the dealers scan tool is required to program a PCM
Under the hood on the passenger side firewall
P0340 Camshaft position sensor circuit P0340 (M) No Cam Signal At PCM No fuel sync.
The PCM (Power Control Module) on a 2001 Dodge Intrepid is located on the right side of the engine compartment just in front of the fuse/relay block. It is typically silver. There are two wiring harnesses that plug into the side.
where is the PCM or power control module, on a 2001 dodge ram p/u.
The PCM can be rest on a 1998 Dodge Stratus by connecting an ODBII code reader. It reads all the information stored in the computer and can directly reset the ECM as needed.
PCM internal failure.PCM internal failure.
It has a PCM/ECM that is located under the hood on the drivers side near the front end of the engine compartment. It is made of cast aluminum and has multiple connectors.
Not with out destroying it.
The pcm of a 2001 Taurus should be located under the hood. The unit is bolted onto the firewall on the passenger side.
The PCM uses a dozen sensors that are located all over the engine.
In the truck
could the pcm fuse be blowing because of a short in the air conditioning switch I have seen the starter be the cause of a blown pcm fuse.
The pcm is located on the drivers side of car, by the radiator.
PCM internal processor failure.PCM internal processor failure.
That is the PCM on the driver's side fender.That is the PCM on the driver's side fender.
It does control the alternators charging of the battery.
the pcm fuse on the 06 ram 1500 is #31
The 2004 Dodge Intrepid PCM power control module can be found on the firewall in the engine compartment. The PCM power control module will be on the passenger side of the firewall.
There is no such thing as a cam sensor valve. The camshaft position sensor is powered by the PCM, there is no individual fuse.
No, the years have to match.
On my '95 Dodge Stratus, it is located in a separate relay box located directly above the power distribution box. If you remove the air intake hose, you will see it. To access it, you will need to remove the air intake hose, move the cover for the remote positive battery terminal, and remove the rear cable for the PCM. Inside this relay box are the fan relays (hi and lo), the starter relay and the ASD relay. Hope this helps.
the Pcm is located to the front right of the engine compartment under the washer fill tube and to the right of the battery