Chevy S-10
Nissan Trucks and SUVs
Chevy Blazer S-10

Where is the pcv valve located on 1995 Nissan Pick-up?

858687

Top Answer
User Avatar
Wiki User
2005-05-08 16:41:59
2005-05-08 16:41:59

The pcv valve on the 2.4 l engine is located behind the alternator and the engine oil filter. The best way to change it is to go thru the wheel well. Take off the passenger front wheel, lift or remove the rubber splash curtain, remove the oil filter, disconnect the rubber vacuum hose, then use a 19 mm wrench to remove the pcv valve. I've found it easier to remove the two 10 mm retaining screws of the bracket that is securing two metal lines and an electrical connector for a little more accessibility. Changing the oil at the same time you do this is highly recommended for your convenience.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

1995 nissan pickup has a expansion valve rather than a orfice tube and is located on the evap.

User Avatar

the air intake valve is located on the side if your air cleaner/air box.

User Avatar

It is bolted to the bottom of the throttle body.

User Avatar

where is egr temp sensor located in 97 nissan pickup l4

User Avatar

where is the horn located on a 1995 Nissan v6 pickup truck? under the front bumber,their are 2 horns, ahigh and low tone.

User Avatar

on the right side of the pickup follow the positive cable.

User Avatar

follow your top radiator hose to your intake,its in their.

User Avatar

The EGR valve is bolted to the rear cylinder head at the transaxle end

User Avatar

how to adjust headlite on 1995 nissian pickup

User Avatar

below the raditor hose that's connected to the thermostat.

User Avatar

The pilot bearing sits in the back end of the crankshaft, where the transmission side is.

User Avatar

what is the Factory front ride height for a 1994 nissan pickup

User Avatar

I HAVE A 1995 NISSAN XE PICKUP WITH 322230 MILES ON IT.

User Avatar

drop the pan, then the valve body, the solenoid is above that

User Avatar

yes it does it mite be the postioning senser located above your transmission housing

User Avatar

It is either screwed into the pressure line on the side of the transmission, or it is inside on the valve body.

User Avatar

below your top end of radiator hose.

User Avatar

where is the pcv valve located on a 1995 Isuzu rodeo v6 3.2l


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.