Crankcases and PCV Valves
Chevy S-10
Toyota Trucks and SUVs
Grand Am SE

Where is the pcv valve located on a 1989 V-6 3.0 Toyota pickup?

171819

Top Answer
User Avatar
Wiki User
Answered
2006-07-12 21:35:15
2006-07-12 21:35:15

It's comes out of the passenger side rocker arm cover. There's a mess of vacuum lines coming off the intake plenum, and it's directly under them. It's nearly impossible to get to it without removing the intake plenum. Reference a Chilton's manual for directions, and make SURE that you label all vacuum and coolant lines accurately.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


The fuse for the wipers on a 1989 Toyota pickup are located under the dash, near the hood release. It is in the main fuse panel which controls most of the vehicle's electronics.

The 1989 Chevrolet S 10 pickup idle control valve is located on the side of the engine. You will find the valve below the fuel injector pump.

The ECM (computer) is located on the passenger side kick panel!

It is located on the bottom of the windshield washer reservoir.

well, considering that there is no 1989 Toyota tacoma, i wouldn't think so..if you're talking about a 1989 Toyota pickup, then no

The headlight relay on a 1989 Toyota pickup is located on the right side of the engine compartment. There is a fuse box on the right-hand side fender wall. The headlight relay is in this fuse box.

The 1989 Toyota pickup had a curb weight that ranged from 2,565 pounds to 3,765 pounds. The '89 Toyota pickup was selected as Motor Trend's 'Truck of the Year.'

the starter is located under the right front wheel well. remove the tire and you can see it.

The 1989 Mercury Sable 3.0 liter engine EGR valve is located on the firewall. The valve will be on the passenger side of the firewall.

Don't think the 1989 Toyota Camry came with an airbag system.

Gear oil, Best place to get it is at WALMART.

You add automatic transmission fluid to a 1989 V6 3.0 Toyota pickup truck through the filler tube in the engine compartment. This is also used to check the fluid level.

The cold start injecter is located in the middle of the intake manifold with the brake master cly. right in the way

The pcv valve on a 1989 Camaro is located in the top of the valve cover. It plugs into a rubber grommet and is easily replaceable.

top of the valve cover closer to the rear with a hose going straight to the EFI

above the oil filter to the back alittle

the 89 toys had the 22r 22re and 3.0 v6

where is the EGR valve on a 1989 mazda b2200

Not sure about the 1989, but 1990-1993 it goes into the valve cover. Look for a hose running to the valve cover and the PCV valve should be what is at the end of it pushed into the valve cover.

remove cowling it is on the passenger side valve cover


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.