The PCV valve is located just to the right of the alternator...take off the 3800 cover (usually gray in color), and its behind the alternator and to the right of it, and you will see it popping out of the engine block right on the top of the engine case....its best to remove the alternator...u have to remove it to get to the pcv valve and replace it....
mine does not have one
By the thermostat housing - follow upper radiator hose back to block.
where is the pcv valve located on a 2001 buick lesabre
The PCV valve on a 1995 Buick Park Avenue is located on the top of the valve cover. Twist the valve and pull to remove and replace it.
where dose a pcv valve go no 1996 buick lasaber...
On a 1993 Buick Regal 3.1L, the PCV valve is located on the intake manifold. It is situated underneath the MAP sensor.
the pcv should be near the front valve cover
driver side valve cover
The pcv valve on a 1989 Camaro is located in the top of the valve cover. It plugs into a rubber grommet and is easily replaceable.
The PCV valve should be on top of the valve cover at the back. The valve just plugs in, and slides out of the rubber hose.
The PCV valve for a 1999 Regal 3.8 is located on the top of the valve cover. The valve pulls out to replace it.
Remove the vacuum hose from your 1989 Oldsmobile 3.8 liter engine PCV valve. Remove the retaining bolts from the valve. Reverse the process to install the new PCV valve.
It is in the valve cover.
the PCV valve is located on the valve cover of a 1991 Regal Custom. It is plugged in and can be easily changed.
located on vale cover
Not sure about the 1989, but 1990-1993 it goes into the valve cover. Look for a hose running to the valve cover and the PCV valve should be what is at the end of it pushed into the valve cover.
The PCV valve for a 2001 Buick LeSabre is located in the top of one of the valve covers. It is a plug in unit and is easily changed.
The PCV valve on a 1994 Regal Custom should be located on top of the valve cover. It is a plug in type and is easily changed.
PCV Valve is located near front of hood on the engine block between the fuel injectors.
When you shake the PCV valve it should rattle. If it does not rattle then it is probably stuck and should be replaced.
Under the alternator. You must remove the alternator to get to it.
4.0? Those actually dont have PCV valves, it is the rubber grommet on top of the valve cover
In the right rear of the valve cover.
Do you mean the PCV (Positive Crankcase Ventilation) valve? The PCV valve should be on the top of the motor, either in one of the valve covers or in the coverplate on top of the block.
The PCV valve plugs into the rocker arms cover or intake manifold.