Dodge Dakota
Dodge Durango

Where is the pcv valve on a Dodge Durango?

585960

Top Answer
User Avatar
Wiki User
Answered
2007-02-04 14:50:02
2007-02-04 14:50:02

On a 2000 Durango V8 the PCV is located on the side of the oil fill tube under the cap

123
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


The PCV value on a 2003 Dodge Durango is on the side of the oil fill shaft.

The PCV valve is located in the valve cover, on the 4.7L it is in the side of the oil filler housing.

Check valve cover, it has a vac hose if that helps.

The PCV valve is located on the driver side valve cover near the fire wall. It is blue plastic connected to a black plastic sleeve in the valve cover. You will need a set of spanner wrenches to get it out.

Where is the pcv valve on 2007 dodge dakota 4.7 mag. Eng.and the egr valve also?

Change the sparkplugs,plug wires, distributor cap, rotor,pcv valve and possibly the air filter if it is bad.

The 2004 Dodge Durango EGR valve can be found on the firewall in the engine compartment. The EGR valve will be on the passenger side of the firewall.

The PCV valve on a 1991 Dodge Dynasty 3.0 engine is on the passenger side of the vehicle. It is on the crankcase.

A Dodge Durango does not have a water control valve in the heater plumbing. The cabin temperature is controlled with airflow control doors.

Center of the rear valve cover.

The valve is in the center of the rear valve cover.

Attached to the valve cover is a hose on the driver side. Unscrew the nut closest to the valve cover and that is the PCV valve. It is a straight PCV valve, not the elbow shape you may be looking for.

go to the local auto shop and tell them you ned your pcv valve replaced

The PCV valve is located on the side of the oil filler.

If you are standing in front of the vehicle, I believe it is to the left of the throttle body on the rear of the intake under those plastic covers where you can`t see it.

the expansion valve is on the passenger side firewall in the engine compartment.

On my '02 Dakota the PCV valve is on the driver's side valve cover. .

On the 2.8 it's on top of the plenum at the back. disconnect the hose & unscrew the pcv valve & replace.

Yes, it is located in the side of the oil filler housing.

The PCV valve on a Dodge Ram 1500 5.7 is located in the air filter hose that goes from the air filter to the motor. On any vehicle, the PCV valve can be located by starting at the air filter and going to the end of the connecting hose at the motor.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.