its located on top of the valve cover. its located on top of the valve cover.
its on the rear of vavle cover,top and in the middle of it
top rear of vavle cover under upper intake manifold
It uses an orifice in the top rear of the vavle cover not a PCV vavle.
it is in the back of vavle cover on firewall side. you can't see it unless you remove the intake plenum.
pull the pcv valve out of the vavle cover grommet, pull the hose off of it, put a new one in, put the hose back on, yay!!
does the 2006 silverado have a pcv valve
there isn't one im pretty sure if there is it will be in the valve covers
yes in the vavle cover.
on the valve cover as your faceing the car you will see a hose on the left side of the vavle cover. This hose goes to the intake plentum. the hose on the valve cover end goes to a connection that has a 19 mm nut screwed into the valve cover.loosen this nut remove the plastic cover and look in vavle cover. you will see the pcv vavle take a pair of needle nose and pull old pcv vavle out and replace.
The pcv vavle is built in through the valve cover, so not an actual pcv vavle you would see on an average car, if it starts going bad your idle is going to go haywire, an occasional loud squealing, you have to replace the valve cover, which is 136.00. (PCV-Positive Crankcase Venalation
its usually in the drivers side vavle cover. look for a 3/8 rubber hose going to the valve cover. the pcv vavle goes into a rubber grommet and usually comes out at 90 degree angle.
The PCV vavle is located in the rear valve cover just behind the throttle body