answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered 2008-03-25 17:43:06

Top left hand side of the engine. There is a pully and the resevior is next to is. That's the PS. Top left hand side of the engine. There is a pully and the resevior is next to is. That's the PS. Top left hand side of the engine. There is a pully and the resevior is next to is. That's the PS.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


Because they have no power steering. I have a 99...


how do you change power steering pump for chevy express van 1998 v6


how hard is it to replace a water pump on a 1998 chevy venture van?


no- 1998-2000 Chevy Venture vans only have a relay for the fuel pump and no fuse.


The wiper motor on a 1998 Chevy Venture is up under the vents next to the windshield. It is bolted to the firewall.



There are two fuse boxes on a 1998 Chevy Venture. One is located under the dash on the driver's side, and the other is under the hood.


ABOVE YOUR POWER STEERING RACK LOCATED ON THE FIREWALL


Search Wiki for 1998 Chevy Suburban power steering pump replacement, the author based his answer on a 1997. Enjoy


what is the coil firing order on a 1998 chevy venture van with a 3400 engine?


There is reaslly no bleeding a power steering pump. Make sure the hoses and hydraulic side connections are snug and fit. as you fill the reservoir with new fluid. Making sure it is below the fill level... this ensures that the fluid can circulate and automatically bleed itself


Under instrument panel on drivers side on the outboard edge


Just had it done on my 1998 Venture - It cost about 900.00


it is located behind the power steering pump. You need to remove the power steering pump and the rest is self explanatory.


how ican find the transmition solenoid tourque for 1998 chev venture


How do you remove the steering wheel on a 1998 Chevy astro van


its on the right side of the valve cover, near the power steering pump.


It is by the power steering pump. You might have to remove the power steering pump. It took me one hour to remove the old sensor and about twenty minute to put on the new one.


Yes, those GM 3400 motors are the same. The transmissions are different -- 4L60e versus a 4L65e


for my 2000 Chevy Venture I use DexCool. It is the ONLY one recommended by GM.


Some model has it, some doesn't, on the left there should be a FUILD RESERVOR in Yellow which indicate the car has power steering. If there is none, then it doesn't. Most 4 door Metro 4 cylinder has power steering but not the hatch version. I have seen some 4 door has no power steering.


Power steering fluid I believe is universal, the easiest way to know for sure it to got to your local auto store and ask them to show you the power steering fluid. If the ask you what kind of car, you can tell them and have your answer.


When owning a car, a person should know the ins and outs of the vehicle. The 1998 Chevy Blazer does have the rack and pinion steering.?æ


it is located behind the power steering pump. You need to remove the power steering pump to get to it which requires removing the engine mount next to it to get the bottom bolt out of the power steering pump. The sensor is directly behind the power steering pump. You can follow the cable that goes behind the pump. It is the only one there.


It is on the front of the motor, it will be the bottom most pully.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.