Ford Expedition XLT
Ford F-250
Ford F-350
Plumbing

Where is the pressure differential valve located on a 1988 f-250?

131415

Top Answer
User Avatar
Wiki User
2008-04-18 01:15:45
2008-04-18 01:15:45

assume you mean Brake PDV... is located on the frame directly below the master cylinder.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

were is the fuel regulator located on a 1988 chevrolet celebrity ? The fuel pressure regulator is located under the intake manifold on the 2.8 V-6 engine but the pressure (Schrader type) test valve port is on the front of the engine to the right and just below the oil filler cap.

User Avatar

right in front of the compressor the alternator is right below it take off the black cap and there it is

User Avatar

The 1988 Chevy Corsica air conditioning service valves can be found on top of the air conditioning compressor. The air conditioning service valves are labeled as the low pressure valve and the high pressure valve.

User Avatar

Fuel Pressure Regulator is located on the fuel rail.

User Avatar

Facing the front of the truck, it is located on the intake manifold on the right side of the carb.

User Avatar

It should be at the base of the throttle body.

User Avatar

It is located in the top of the motor with a rubber tube/hose going to the air cleaner I believe.

User Avatar

The vehicle speed sensor is located at the rear differential on a 1998 Bronco II. This also serves as the ABS sensor.รŠ

User Avatar

Directly behind the power steering pump. There is a 5/8th hose, pull up from valve cover.

User Avatar

Freon valve on my 1989 Buick Regal Custom 3.1 V-6 located on driver side under the area of battery tray. Hope this helps!

User Avatar

The oil pressure sensor on a 1988 Chevy 1500 5.7 is located on the engine. It is on the right side, near the intake manifold.

User Avatar

your accuater is starting to go its located on the front differential drive safe

User Avatar

In the fuel tank, it is electric high pressure

User Avatar

it is located on the back of the throttle body driver side position

User Avatar

It is located behind (toward the rear of truck) The oil add chamber on the passanger side valve cover. Pull the hose out of the valve cover and there you'll find the PCV Valve

User Avatar

The 1988 Jeep Cherokee air conditioning low pressure port is located on the air conditioning compressor. The low pressure port will be on the right hand side of the compressor.

User Avatar

the pressure should be between 35 and 42 psi in the fuel rail. It has a valve like the one for air in the tires to measure the fuel pressure.... MOA.

User Avatar

in between the carb and valve cover in the intake . sticking straight up with one hose on it .it screws into the intake . have fun. they can be fun to remove.

User Avatar

it does not have a high pressure switch all it has is a evaporator temp sensor/switch.

User Avatar

It's on the accumulator. Should have a blue cap on it. The accumulator (also called receiver/dryer) is the large aluminum "can" looking part. It will be on the passenger side next to the fender.

User Avatar

The oil pressure sending switch on a 1988 Chevrolet Celebrity with 2.8L V6 is located on the bottom of the block near the oil filter.

User Avatar

At the rearmost section of the engine to the right of the distributor.

User Avatar

were is the power steering pressure switch on a 1988 oldsmobile cutlass 2.8 engine


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.