answersLogoWhite

0


Best Answer
Copy

fuel pressure release valve ? Just disconnect wire harness from tank or remove fuse to fuel pump then start and run engine until it runs out of fuel in line then continue to try to start for 20 seconds then disconect battery and service pump or injectors as the fuel system is now empty of fuel and pressure.

User Avatar

Wiki User

โˆ™ 2006-01-15 01:57:14
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Add your answer:

Earn +5 pts
Q: Where is the pressure release valve for the fuel line of a 1990 Buick Skylark?
Write your answer...
Submit

Related Questions

Where is the PCV valve located on a 1991 Buick Skylark?

The PVC valve for a 1991 Skylark should be located on the top of the valve cover. It is a plug in type, twist and pull to remove.


Where is the pcv valve located on a 1975 Buick Skylark?

Driver's side valve cover top, locate 3/4" hose its on the end that is inserted into the valve cover.


Does the heater core have a pressure release valve?

no pressure release valve


Where the location on the fuel shut off valve 98 Buick skylark?

Doesn't have one. That's a Ford feature, not GM


Where is the port to put freon into a 1997 buick skylark you already have the conversion kit?

Underneath the car. no need to jack the car up. its a blue valve


Where is the AC recharge valve located on a 1995 Buick Skylark?

The ac recharge port is the low side port. It is on the hoses on the passenger side of the engine close to the belts.


How do you remove valve cover 1995 Buick skylark custom?

What kind of engine is it? I know that Chilton's and Haines manuals have the procedure. You should be able to find them at Amazon or Ebay.


1994 buick skylark 3.1 high idle and surges any speed?

It might be a MAP sensor, EGR valve or something like that. Maybe a vacuum leak.


How do you release fuel pressure on 2001 impala?

there should be a valve on the fuel rail on the engine that you release the pressure, it looks just like a tire valve.


What is the purpose of geyser pressure valve?

The purpose of a pressure relief valve in a geyser is to release the pressure created inside due to evaporation of water.


How boiler safety valve works?

A boiler safety valve is a valve that is set to open when the pressure in the boiler reaches a limit. The valve opens to allow excess pressure to escape the boiler. This release of excess pressure stops the boiler from exploding.


Where is the PVC valve on a 1999 Buick lesabre?

where dose a pcv valve go no 1996 buick lasaber...


Where is heater control valve on 1994 Buick regal?

Where is the heater control valve on a 1994 Buick Regal


Where is the pressure release valve on a 2001 impala?

More to the point, where is the Impala at the pressure relief valve, right? Try the local Oriental Massage parlor.


Where is the egr valve on a 1993 Buick Skylark?

It's near the top of the engine, close to the rear spark plug wires. It's round and either brass or a dark gray color. You can't miss it.


What is the cap covered nipple valve in the U of the fuel rail assembly of a 1998 Buick Century V6 engine used for?

To hook up a gauge to measure fuel preasure and to run injector cleaner through it Fuel line pressure release valve. (schrader)


Where is the starter in a 1972 Buick skylark?

It is located on the passenger side of the motor below the passenger side valve cover. You can follow the RED, positive, battery cable down to it as the cable should be connected to the stater motor.


Where is low pressure port on 1999 Buick Century?

On my 99 Century 3.1l V6, the low pressure port is on the inverted "U" section of the low pressure line on the firewall near the EGR valve.


Where is heater control valve on 1996 buick park ave?

were heater control valve for 1996 buick park avenue


Where is the tire presure sensor on a 2007 Buick?

Most tire pressure sensors are built into the valve stems in the wheel. The send a signal to a reciver on the vehicle to monitor tire pressure


How do you replace PCV valve on 1995 Buick Park Avenue?

The PCV valve on a 1995 Buick Park Avenue is located on the top of the valve cover. Twist the valve and pull to remove and replace it.


What is difference between pressure reducing valve and pressure relief valve?

pressure relief valve relief the excess pressure which is developed in the syatem, while pressure reducing valve reduces the pressure and supply it to the system.


Where is the PCV valve located on a 1990 Buick Skylark 2.3 L engine?

the 2.3 and 2.4 engines dont have a pcv valve,they have an oil/air separator located on the right side of the engine as you look at the engine from the front.it looks like a black box with 3 hoses attached to it.


How to replace pressure release valve in residential plumbing system?

That would depend on which part of the system the RELIEF valve is located


Is there a pressure release valve built into inground pools for wet weather?

No, not usually.