At the bottom of the radiator, passenger side. You will have to remove some plastic panels to access it.
blower motor eltavolitas 1998 acura tl3.2
there are two metal looking lines that screw into the radiator that is the cooling side
The 1996 Mercury cooling fan relay switch is on the back of the cooling fan motor. The relay switch should be labeled as such.
The radiator is located in front the engine cooling fan and shroud, at the front of the motor. _____________chassis_________________ _____________________________________ Fire wall motor ~cooling fan~ radiator ________________________________________ chassis
2.27 galons is the coolant capacity for the acura RL 96-04.
The ECT or the Engine Coolant Temperature Sensor is a switch. This switch is located on the bottom of the radiator in the 1996 Camry.
above the radiator fan but be careful handling them - they are notorius for the wires coming out of the male plug in
Any time you flush out the cooling system you need to bleed the cooling system.
It COULD be the radiator cooling fan, the temperature switch that controls the radiator cooling fan, a blown fuse that controls the radiator cooling fan (in that case, why did the fuse blow???) or a worn water pump.The most difficult part will be finding out which. None of them are that difficult to repair, but narrowing down the problem requires that you understand what's going on and comprehend the cause and effect of complex systems, such as an automobile's electro-mechanical interaction.
just follow the lower radiator hose to the engine and that is where it is sitting@
If yoor 1996 Integra has the1.8L engine, the thermostat is located at the back of the motor at the end of the bottom radiator hose.
The cooling system on this vehicle does not use a radiator cap on the radiator but on a remote tank. It may have a different (larger) cap on it than what you are used to seeing on the radiator.