It is in the exhaust manifold on the rear of the engine.
The oxygen sensor is screwed into the exhaust manifold on the rear of the engine on a 1995 Chrysler Town and Country.
The O2 sensor is in the front of the engine. If you look at the exhaust manifold by the heat shield you will see it. It screws into the exhaust and has a single wire coming out of it running back toward the drivers side of the engine. Easy to change
where is (are) the location(s) of the oxygen sensor(s) on a 1995 Ford Thunderbird V8 ? I know where the front ones are I just can't seem to find the rear ones.
The front sensor is reading wether your air/fuel mixture is correct and computer makes adjustments according to a rich or lean reading from o2 sensor. The rear sensor is reading what comes out from the cat/converter to see if converter is doing is job in removing pollutants.
Remove the vacuum hose from the O2 sensor. Remove the wiring harness. Remove the O2 sensor retaining screws. Reverse the process to install the new O2 sensor.
the o2 sensor is located in the exhaust manifold. As you pop the hood and look at the engine, you should see a silver colored heat shield. Unplug the old O2 sensor. Then remove the heat shield. Its easier this way (10 MM bolts). Get a O2 sensor socket and remove the sensor and replace. The rear sensor is located in 1 0f 3 places. Either before in or after the catalytic converter. For this one you just get the O2 sensor socket and remove. (When the engine is cold) Madd Dogg 40/40
The O2 sensor on the 1994 accord dx, lx, or ex is the same, and there are two O2 sensor on the 1994 accord, fornt and the rear. Fornt one is located on the top and it is right on the header and the rear O2 sensor should locate on your cat converter right in the middle of your car. So check which sensor that you need and replace it.
replace rear o2 sensor.
With an o2 sensor socket.
Lambda is o2 sensor in exhaust pipe.
1995 vehicles did not have post cat o2 sensors.
if 4,6L Color is usually yellow or red egr - under manifold in rear O2 - rear back in axhaust manifold
The upstream O2 sensor is mounted in the ehxaust manifold The downstream O2 sensor is mounted in the exhaust pipe after the catalytic converter
No. do you mean the front or rear o2? The front might be an A/F sensor. Big difference. But no, there isn't.
just after the cattalitic converter
It is your 2nd (Bank 2) O2 sensor.
it is the rear sensor bank 1 (the one after the converter)
Start at the exhaust manifold and follow the exhaust pipe toward the rear of the vehicle and you will find the O2 sensor.
Downstream O2 sensor is an O2 sensor after the catalytic converter. Upstream O2 sensor is an O2 sensor before the catalytic converter.
4 wires, the black ones are the O2 heater (on the sensor side), the white and green are the O2 sensor itself
The bank 2 pre cat O2 sensor is in the rear exhaust manifold, the bank2 post cat O2 sensor is under the car after the catalytic converter, P/S nest to transmission.