The rear oil seal on any automotive engine is located at the rear of the crankshaft, which is usually only accessible once the oilpan is removed. The exceptions to this rule concerning the oilpan still involve removal of the flywheel or flex-plate to gain access, as these seals are installed from the exterior of the crankcase onto the crankshaft.
There are four motor mounts located on a 1990 Chevy Lumina. Two on either side of the engine. One the rear and one in front of the engine.
The sensor is located in the rear exhaust manifold.
6 cyl.? Look at the lower rear end of the engine.
rear left facing front of vehicle
The PCV valve is located in the rear valve cover next to the firewall. It can be reached and changed without rotating the engine forward although it is a bit of a struggle.
front
Begin by removing the tire and wheel from your 2000 Chevy Lumina. Remove the brake spring and the break caliper. The rear brakes will come off.
Located in rear of engine under intake manifold , left side of engine
Try the rear side of the radiator approx. 1/3 down from the top
if this is front wheel drive it will be on the passanger side bottom of engine good luck replacing that it it is rear wheel drive its in the front bottom a little eaiser
The oil pressure switch on a 1997 Chevy Tahoe is located on the back of the engine. It is in the center-rear part of the engine.
At the left rear under the engine.