GM vehicles are not equipped with an inertia switch.
You can try to reset your brake light switch by unplugging the brake light switch and plugging it back in. If that does not solve your problem you will need to replace the brake light switch.
Put the new serpentine belt on to your 1992 Chevy Corsica pulleys. Push the tensioner pulley to the left to tighten the serpentine belt.
In the exhaust system before the catalytic converter.
passengers side top (relays)
im sure it is, and i doubt its worth it.
Run a new one from the blower motor body to ground
The easiest way to reset the ABS light in a 1992 Chevy Lumina is to disconnect the battery for about 30 minutes. When it is reconnected, the light should be reset.
Could be your crank sensor. These are very common to fail on these cars.
Leak in heater core
GM vehicles do not use inertia/reset switches.
FIRE WALL SIDE OF ENGINE, A LITTLE UNDER THE EGR VALVE. T HEMPLE
did you look inside the centre console? i drive an '88 and it wasn't until about a month after i got it that i found the trunk release button while i was trying to fish out some change from the very bottom of the storage bin.
of the three in on the bottom of the rack its the one in the middle.
The spring holding the door button in place has fallen out. Remove the door handle and replace.
It should be either in the trunk or the passenger or driver floorboard. To reset ot, push the button back down.
IF IT'S A 3.1 ENGINE IT'S LOCATED ON THE BACK, FACING THE FIREWAL, VALVE COVER. SLIGHTLY UNDER THE INTAKE PLENIUM.
Press the E/M button. I think its to the left of the steering wheel.
Since the 92 Chevy Corsica is equipped with SRS (Saftey Restraint System), ie: Airbags, which is located in the steering wheel. In order to replace the turn signal switch you must remove the steering wheel. Therefore I would only highly advise you to take it to a dealer to have this done.
There is a switch behind the left front speaker that resets it.
29s, i replaced the oil pressure sender on my 92 corsica 3.1 and i did it while having my starter changed because it is located directly above the starter on the engine block.
what is the wire code for a 92 Chevy slverado for the memory
start with fuel filter could be clogged, could be faulty fuel pump.