Ford Bronco II
Ford F-150
The Difference Between

Where is the single wire in-line SPOUT connector on a 1989 Bronco II 2.9 liter fuel injected engine?

737475

Top Answer
User Avatar
Wiki User
Answered
2015-07-17 17:57:19
2015-07-17 17:57:19

follow the wiring harness towards the pass. side of the engine compartment from the distributor,it only leads to one thing!!!

If you have an A/C equipped model like I do, the SPOUT connector is right up against the evaporator housing on the engine side, hanging out of a wire harness. It's a black connector shell with 2 short yellow/green wires on one end, and a removable plug on the other. It's taped to the side of the harness, but not wrapped in it.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


On a 1996 Ford Bronco : The 5.0 and 5.8 litre V8 engines from the factory are fuel injected , so there is no carburetor ( the 4.9 litre inline six cylinder engine was not offerred in the 1996 Ford Bronco model )

( YES ) In a 1988 Ford Bronco , the 3 factory available engines are fuel injected 4.9 liter / 300 cubic inch inline six cylinder 5.0 / 302 V8 5.8 / 351 V8

No, it is an inline engine.No, it is an inline engine.

The difference between a v engine and inline engine is that in v type engine the pistons and cylinders are aligned in in a v shape and in an inline type engine the pistons and cylinders are all vertical or inline with each other.

wer is the spout connector on 1992 ford e150 v8 5.0 liter

.044 hope this helps =========================================================== The above answer is correct if you have the 4.9L inline six cylinder or the 5.8L V8 engines ( if you have the 5.0L / 302 cubic inch V8 engine in your 1993 Ford Bronco the spark plugs are gapped at .054 inch )

Hmmm. Between the head and the block of the engine. The fuel injected Vortec 4200 LL8 all aluminum inline six is a dual overhead cam engine. The procedure is a little more labor intensive than the conventional OHV inline six head gasket replacement. www.trailvoy.com Trailblazer enthusiasts forum with all the answers.

an engine with all of the cylinders in a straight line, instead of in a 'v' formation.

A 1.6L inline 4-cylinder BP family engine.

There is an inline spout connector, kind of like a plug you would plug into the wall, that you have to disconnect before using timing light. This puts the engine in base timing. Set timing to specs and then plug inline spout connector back up.

What engine and what year?

If it is carburated itis in the inlet nut of the carb. If injected it is inline.

The 2004 Volvo XC90 has an inline 5 engine.

The 2014 Toyota Tacoma has an inline 4 engine.

The 2003 MINI Cooper has an inline 4 engine.

The 2004 Honda Civic has an inline 4 engine.

The 2003 Kia Rio has an inline 4 engine.

The 2011 Nissan JUKE has an inline 4 engine.

The 2010 Jeep Compass has an inline 4 engine.

The 2003 Honda Insight has an inline 3 engine.

The 2004 Honda Accord has an inline 4 engine.

The 2014 Chevrolet Spark has an inline 4 engine.

The 2006 Hyundai Tucson has an inline 4 engine.

The 2013 Audi TT has an inline 4 engine.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.