answersLogoWhite
notificationBell

Top Answer
User Avatar
Wiki User
Answered 2008-04-02 20:41:11

The starter solenoid should be located on the inside fender close to the battery. It will have the positive battery cable connected to it.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Your Answer

Related Questions


where is the shift solenoid on a 1996 ford ranger 4x4 with a 4.0 v6


where are the fuseible links located on a 2000 ford ranger


where is the electronic relay located on a 2000 ford ranger xlt



how do you change a fuel filter and were is it located on a 2000 xlt ford ranger


it is located on the side of the stater it will come when you remove the starter


It should be attached to the short positive battery cable.



can you use a transmission from a 1993 ford ranger in a 2000 ford ranger?


on your starter which should be next to the oil pan on the underside of your truck


where is the fusible link on a 1996 ford ranger xlt


Yes I just replaced the solenoid for my Ranger and it is located on the passenger side right side panel under the hood right in eyes veiw. Hope this helps. Val


bolt pattern for 2000 ford ranger & ft pounds



The oil drain plug on the 2000 Ford Ranger is on the rear of the oil pan. It is located under the vehicle near the center.


it is located on case relay of FORD RANGER 4WD..


The solenoid is located inside the starter.


what type of radiator fluid does a 2000 ford ranger take?


No , the engines in a 2000 ford Ranger are E.D.I.S. ( Electronic Distributorless Ignition System )


5W-30 , according to the 2000 Ford Ranger Owner Guide


Bank 1 is the passenger side of a V6 engine in a 2000 Ford Ranger


How do you install a rear sliding window on a 2000 Ford Ranger?


fuel pump is located inside the gas tank


The EGR Solenoid on the 3.0L Flex Fuel is located behind and to the right of the distributor cap. It sticks up about an inch and a half and is about 1 and a quarter inch in diameter


How much weight can i pull behind my ford ranger 2000 xlt