Cable is mechanical.
The 95 Camry does not have a mechanical speedometer cable. There is a speed sensor located on the top of the transmission that is connected by wire to the speedometer.
At the top the speedometer cable is connected to a little gear in the speedometer guage, and on the bottom end it is connected to a little gear in the car's transmission.
Look at the left side of the front axle. There should be a cable running there between the lower leg of the fork and the hub of the wheel. That's the speedometer cable. The other end should be connected to the back of the speedometer.
the speed ometer cable is connected to transmission,unless its a4 wheel drive,then its connected to the transfer case.
There is no cable.. its electronic
a 1992 Volvo 940 doesn't have a speedometer cable. the speedometer is controlled electronically.
There isn't a speedometer cable. There is a speedometer sensor,where it is located I am still trying to find out. On the tranny or in the speedometer or somewhere else?
There is no speedometer cable. MPH is calibrated using a speed sensor. If your speedometer is not working, you have a bad speed sensor module.
It has an electric speedo and has a speed sensor.
It doesn't have a cable, as it is electric. The speed sensor is on the trans.
speedo connected to gearbox and connected to other end not brken but not working
pop the hood and look right at where the back of the dash is the should be a cable coming out at that spot that's the speedometer cable
There is no cable, the speedo is run electronically.
The speedometer signal is all electronic. There is no cable. The signal comes from speed sensors.The speedometer signal is all electronic. There is no cable. The signal comes from speed sensors.
It doesn't have a speedometer cable.
there is not one it's electronic
The speedometer cable on a 1987 Mazda 323 is located on top of the transmission and travels up to the dashboard. It helps the vehicle's computer monitor speeds constantly.
The speedometer is electronic...there is no speedometer cable.
There is no cable. It's electronic.
A 1994 Plymouth Sundance/Duster does not use a speedometer cable. Instead, it uses a Speed Sensor located on the transmission.
It won't be a speedometer cable like the one you're probably thinking of. On the top of the transmission output shaft, there'll be a speed sensor. Connected to this speed sensor will be wires connected by a quick connect coupler. Unplug that, and you can remove the speed sensor with a ratchet and socket. Rather than a cable which goes directly to the speedometer, the F750 will have a speed sensor which sends a signal to the engine ECM, then the ECM sends a signal to the speedometer.
Since you replaced the sensor, and the speedometer still isn't working it is possible that you will need to replace the speedometer cable. Check the cable first to be sure that it is still properly connected, and if so replace the cable to see if that solves the problem.
The most common reason for a speedometer to fail is a broken speedometer cable. Loosen the nuts on each end of the speedometer cable. Remove the speedometer cable retaining clips. Reverse the process to install the new speedometer cable.
Should be tailshaft area trans.