answersLogoWhite

0


Best Answer

The starter enable relay is located behind the driver side kick panel (where the hood latch release is). To access, there are two screws that hold the kick panel in place. Remove the screws, pull out the kick panel, you will see a black plastic relay with four wires going to it. This is your starter enable relay.

There is no such thing. There is a starter solonoid which is on top of the starter. actually there is a starter enable relay on these camaros. i have an 89 iroc. the starter enable relay is used with the 'pass key' anti-theft system. there is a resistor in the ignition key, without the special key, the car won't start. this pass key system energizes the starter enable relay, allowing voltage to pass to the starter solenoid.

User Avatar

Wiki User

โˆ™ 2009-06-11 04:26:54
This answer is:
User Avatar
Study guides

Add your answer:

Earn +20 pts
Q: Where is the starter enable relay on a 92 Chevy Camaro RS 350ci and what does it look like?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

A picture of the Chevy Camaro starter?

http://www.autopartswarehouse.com/mmp/chevy~camaro~starter~parts.html


Where might the starter enable relay on a 91 Chevy Camaro be?

below left side of I/P near fuse block


Where is the starter enable relay on a 92 chevy camaro rs 305ci located on the car?

behind and above the fuse block to the left of the pedals


Where is the starter located 1993 Chevy Camaro?

The 1993 Chevy Camaro starter can be found on the right hand side of the engine. You can follow the positive at three cable directly to the starter.


How do you remove a starter for Chevy Camaro v8 93?

Begin by removing the positive cable from your 1993 Chevy Camaro battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. The starter will come off.


How much is a starter for a 1995 Chevy Camaro?

with out a core its about $125


Where is the starter relay located on a 1996 3.8l Chevy Camaro?

The starter relay on a 1996 Chevy 3.8l Camaro is located in the engine compartment along the left side. It sends power to operate the starter and prevents overloads.


How do to install a starter on a 89 Chevy Camaro?

The starter on an 89 Chevy Camaro is installed by placing the vehicle on jack stands, attaching the starter wires, and aligning it with the mounting holes. The bolts are place in the starter, torqued down, and the shroud cover attached.


Where does the starter fluid go in a Chevy Camaro?

into the throttle body/ carburetor.


Where is the sensor capteur d'air sensor part?

On my 350ci chevy, it is above/beside the starter on the engine block. BE CAREFUL or you will get a face full of antifreeze!


Where is starter located on a 1997 Chevy Camaro?

underneath on the passenger sidenext to oil pan


Where is the starter located on your 2000 Chevy Camaro?

Where the motor and trans meet on the driver side

People also asked