Geo Storm
BlackBerry Devices
Beaches

Where is the starter found on a 1993 Geo Storm and how do you get it out?

242526

Top Answer
User Avatar
Wiki User
Answered
2008-11-15 04:53:26
2008-11-15 04:53:26

The starter is on the passenger side rear of the motor. You'll have to jack the car up to get to it, and I think its held in by 2 bolts and a few connectors.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


Follow the pos battery cable. It is at the end.

On the 1.6L sohc starter is between the engine and fire wall. By the oil filter.

You can't. They have a distributor pack, and not a cap and rotor. a 1.6 eng 93 geo storm has a distributor cap and rotor!!!

Under the hood, inside a tube, sticking out of the transmission

If you have no spark, you would likely have a problem with the magnito (ignition).

The computer is a litle silver box under the drivers side dash.

no. they stopped making them in 1993. there was also an american cousin also ending in 1993 called a geo storm

DOHC GSi, 130 horsepower, SOHC std 95 horsepower

vins all start with j because there Isuzu (Japanese jdm)

To replace a thermostat on a 1992 Geo Storm first locate the its housing. Once found drain the coolant system and remove the housing from the engine. Replace the thermostat.

top died senter the markes should mach up

Your alternator might be bad and not charging your battery properly.

All GEO Storm starters are interchangeable. It does not matter the year, engine or transmission. You can also get them from any Isuzu Impulse, Stylus, and 89 I-Mark RS. Some of the starters look different, or have different shapes. But all bolt up the same and will work. I have found a few have a different connector for the solinoid. This is delt with by splicing the wire with the correct type of connector from the donor car.

the belt only goes around the crank pulley and alternator pulley

It is next to the drivers side wheel well. You have to remove the air cleaner housing to get to it.

under the hood on the frame rail on drivers side, directly below master cylinder

The starter on a 93 Geo Metro is located on the back side or firewall side of the engine. The battery will need to be disconnected and the cables removed from the solenoid and then the two bolts holding the starter to the engine can be removed. When installing the starter make the battery connection the last thing you do.

Same answer as: "How do you replace a starter on a 92 Geo Prism LSI or GSI?" at this same site.

It is 1-3-4-2 and the dist turns counterclockwise and #1 is on the pass end of the engine.

The Fuse size is listed on the under side of the Fuse Cover.

disconnect battery or connection to starter and take it off.

adjust the clutch cable on top of the trans. adjust the clutch cable on top of the trans.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.