Top rear of engine directly under the air intake tube/throttle body.
All major relays are in the relay box under the hood.
Don't ever !!!!!
on my 1999 ford mercury villager its on top of transmission under the van
The starter on a 1998 Mercury Mountaineer is located on the passenger side of the engine. It is down low, almost underneath the motor.
The starter on a 1998 Mercury Mountaineer is located on the passenger side of the engine. It is down low, almost underneath the motor.
In a 1998 Mercury Villager, the mass air flow sensor is located in the air intake tube. The air intake tube goes from the air box to the intake.
It should be the same.
O2 sensors are always located on the exhaust system.
According to the 1998 Mercury Villager Owner Guide ( 5W-30 ) is the preferred oil
The speed sensor on my Villager is on top of the transmission near the starter. If you look down at the starter while standing on the driver's side of the engine, the speed sensor should be to your right, down on top of the transmission housing about a foot or two toward the rear of the vehicle from the starter. It will have a wire going from it to the firewall right about where the instrument panel is located. Note: The starter is under the area of the throttle.
10w30
The 3.0 litre V6 engine in a 1998 Mercury Villager has a timing BELT