I have a 99 Mazda 626 and my starter is located right next to the oil filter.
I had the same problem on my 98 Mazda 626 and the O2 sensor was faulty.....
How do I replace ignition wires on my 98 Mazda 626 2.0L
With a hammer!
Hi! The fuel doors are not the same size.
It my be your Mass Air Flow Sincere.
There is a pin that needs to be removed to get them out
i believe it is for traction control
does anyone know where a starter is located on a 98 acura 3.5 RL
No spark? Leaking injectors?
The solenoid is located inside the starter.
On the 98 Mazda 626 there are two oxygen sensors, one is located at the front bottom of engine on the drivers side. If I remember correctly it requires a 23mm wrench to remove. The other sensor is located under the bottom on the exhaust pipe just behind the cat. converter. I hope this will lead you in the right direction and good luck.
98-99 Mazda 626 do not have speed sensor. Speed data is obtained from ABS. Therefore if you are having speedometer issue then the problem is more complex as you have expected. Good luck!
I have a 98 626es v6, thermostat is located under air filter housing on the right side of the engine if you are standing at the front of the car facing the engine
The 1998 Mazda 626 DX sedan fuel tank holds 16.9 gallons of gas. It gets 26 miles per gallon in the city and 33 mpg on the highway. The '98 626 produces 125 horsepower at 5,500 rpm.
3.5 litres (3.7 quarts) with oil filter change
Dextron III- GM Type transmission fluid..
i have a 98 Mazda b3000 auto 4x4. where are the shift solenoids located
Most of them, 94-98 The 93:s second gen have a different wiring than the 94-98 when it concerns the engine electrics but mechanically thay are more or less the same. My 94 SE is running with the disty from a Mazda 626, the driveshafts from an Ford Probe GT V6 - 97, the brake discs and brake pads for a Mazda 626. The engine is more or less equal to the Mazda 626 egine, the valve cover differs. The chassie is more or less mechanically a 626. The Probe is an MX-6 with different valve cover and bumpers and the MX-6 is the sportier model of an 626.
The starter on a 98 V6 Camaro should be on the side of the engine block. It is close to the rear at the bell housing.
Follow the positive battery cable from the battery, it will lead you to the starter.
There are two posts on the starter solenoid when the starter is in position the top one is for the positive battery cable. The bottom one should have a very short cable that enters the starter casing. I just replaced the starter in my 98 mazda protege yesterday.
The starter on a 98 Oldsmobile Cutlass is located on the bottom, left side of the engine. It is held in place by a support bracket and bolts.
I PAID $170 FOR MINE IN VA I paid $125 for a radiator online. Installed it myself.
AnswerIt is built into your Mass Air flow sensor so you have to replace the whole thing, for the 98 and up they are separate.
The starter is located on the right hand side of the engine near the bottom. You can follow the positive battery cable from the battery to the starter.