ignition control module is located under the distributor cap
If you mean the Constant Control Relay Module, it is located under the air filter.
The End Result
The ignition module is located between the starter and the spark plugs on most vehicles.
In the trunk
The cruise control computer module is located on the passenger's side of the engine compartment on a 1993 Mercury Villager.
The cruise control module of a 1993 Mercury Villager is located under the passenger side of the dashboard.
where is the ignition control module located on mercury marquis
The 1999 Mercury Sable computer module can be located behind the passenger side dashboard. The dashboard will need to be removed in order to view the computer module.
Inside the distributor
That would be inside the polar control unit
ignition control module is under the distributor cap
The computer module in a 2003 Mercury Mountaineer is located behind the rear right panel in the truck space. The rear right seat belt panel must be removed and then the lower panel. The module is located beneath a green plug.
It would have a starter relay and it is located in the power distribution box under the hood. Remove the black plastic cover and turn the cover over, it will tell you which relay is for the starter.
DO NOT USE EXTERNAL MODULE,COMPUTER DRIVES SIGNAL FOR SPARK & TIMING
Module is located under coil packs at front of engine above starter motor.Label all plug wires, you may have to remove starter to get to it...
The computer control module for a 94 Mercury Cougar is located behind the glove compartment. This allows it to be accessed easily while protecting it from damage.
The ignition module and coil are contained inside the distributor and are not serviced as separate parts.
The Temperature Control Module is located at the center of the instrument panel......
The wiper control module is mounted on a bracket near the steering column support bracket.
The SEC/timer module is piggybacked to the TCM bracket, under the dash, behind the glovebox area.
What is a gem module for 1999 mercury sable? And what does it control?
can't be set. only replaced. and that isn't your problem anyway. replace the crank position sensor, or the fuel pump. then your 1.9 will start.
The standard location of the cruise control module is on the steering wheel. In 1993 some models have a side arm that houses the cruise control module.