the starter is located at the right side of the engine if you r looking at it from the front the starter is located at the right side of the engine if you r looking at it from the front
Why 1988 acura legend downshifts
The starter location differs depending on which generation Acura Legend you are referring to. It is best to address the year and trim level of Legend you are seeking.
How do you bleed the cooling system of a 1988 acura legend? Is there a bleeding screw and where is it located?
The 1991 Acura Legend starter is located on the right hand side of the engine, near the front, at the bottom. You can follow the positive battery cable from the battery to the starter.
To change a 1995 Acura Legend starter, remove the 4 bolts around the intake pipe and lower radiator hose. Remove the starter and replace with new.
You can find your 1988 Acura Integra starter on the right hand side of the engine. You can follow the positive battery cable directly to the starter.
Some parts are, the 2.7liter is but some of it's electrical components are not
99 acura Ti
It is important to use the correct amount of fluid in a car. The 1988 Acura Legend takes about 3.2 quarts of transmission fluid.
must lower the exhaust system
"Considering that there is no such thing as a 1998 Acura Legend, I would dare say that it is impossible." I have a 1988 Acura Legend LS and I am dealing with the same issue. If you figure it out, help me out!
1988 Honda acura legend S-3 light keeps coming on what should I do
check ehow.com cars-repairs
under the steering wheel i guess
Postive battery cable should connect to the starter relay (solenoid)
The fuel filter for a 1988 Legend is located under the hood. It is bolted to the firewall near the top of the engine.
Follow the positive battery cable.
Acura Legend was created in 1986.
The firing order for a 1988 Acura Legend is 1-4-2-5-3-6Additional info FYI: Ignition timing: 15 degrees BTDC #1 cylinder location: RIGHT-REAR
Check your starter it may be grounded when hot.
IF BOTH ARE 4 DR/2 DR YOU SHOULD BE ABLE TO INTERCHANGE BETWEEN THOSE TWO YEARS **********************KKODAL********************************
How do you change transmission in a acura legend?
To replace the starter in a 1989 Acura Legend you must first disconnect the negative cable on the battery. Disconnect the starter motor making sure you label each of the wires as they are removed. Remove the bolts which hold the starter to the engine and slide out the starter. Position the new starter to the engine. Torque the mounting bolts using 32 pounds of foot pressure per bolt. Connect the wires to the starter using the labels as a guide. Reconnect the battery cable and check the starter operation.
Follow the + battery cable -jump the small terminal and the wire to the starter (Make sure in neutral) Starter should operate