Look at the lower rear end of engine
The knock sensor on the 1996 GMC Jimmy 4-wheel drive, 4.3 liter 6-cylinder is mounted in the engine block. Under the hood, look in the lower engine area on the passenger side, beneath the cylinder head.
It is important to have a diagram of the wiring system in a car. The wiring diagram for a 1979 GMC Jimmy can be found it is maintenance manual.
Bottom, passenger side of motor.
Check your battery cables, both sides and both ends. Clean the posts on the battery even if they appear alright.
26 or 30/31 gallon
the starter GMC Yukon?
howdo you change an ignition switch on a 1996 gmc jimmy howdo you change an ignition switch on a 1996 gmc jimmy
My 2000 GMC Jimmy is slow cranking. The battery voltage meter is showing charged so I am assuming that the starter is the problem. Where do I find the starter to remove it?
5x4.75
The starter is on the right side of the engine. The right tire needs to be removed to access the starter.
There are several relay switch is on your 1996 GMC Jimmy. The brake light relay switch can be found below the dashboard in the engine compartment.
a defective starter switch
It's in the Fuel tank
Tom here, my 1996 jimmy 4 4wheel drive has no 2nd, reverse or overdrive?
To change the starter on a GMC Jimmy 95 you must look under the truck and locate the starter. There will be a bar in the way of removing the starter. You will have to remove the two screws and manuver the starter around the bar. This will be tricky so take your time. Once you remove the starter replace with the new one and manuver back in place screw in and your done.
What size Motor?
5 on 4 3/4".