Starters and Ignition Systems
Buick LeSabre
DIY Projects

Where is the starter on a 1998 Buick LeSabre?

101112

Top Answer
User Avatar
Wiki User
2009-07-22 18:39:07
2009-07-22 18:39:07

look under the car from the front its just above the main cross member a little bit to the driver side the wirers are on the passanger side you will need a 15 mm socket to remove it

12
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Which relay is the starter relay on a 1994 buick lesabre

User Avatar

Where do you find starter relay for 99 buick lesabre custom

User Avatar

The starter on a 92 Buick LeSabre is replaced by disconnecting the battery, removing the retaining bolts, and lowering the starter. The wiring harness can then be disconnected and a new starter installed.

User Avatar

The 1998 Buick LeSabre solenoid can be found on the firewall in the engine compartment. There will be three solenoids on the firewall.

User Avatar

The starter on a 1989 Buick LeSabre can be found on the driver's side of the engine. It is down low, back by the bell housing for the transmission.

User Avatar

How do you install a heater core on a 1998 buick lesabre

User Avatar

were can i locate and replace a starter for a 1998 buick regal?

User Avatar

The 1998 Buick LeSabre custom sedan has a curb weight of 3,443 pounds. It has a wheel base of 110.8 inches and a ground clearance of 5.5 inches.

User Avatar

Struts on a 1998 Buick LeSabre are changed by jacking the vehicle up, removing the wheel, and unbolting the strut. It can then be pulled from its mounts and a new strut put in place.

User Avatar

The fuel shut off reset button is located inside the 1998 Buick LeSabre. It can be found on the firewall in the front passenger side.

User Avatar

Do you mean the starter solenoid? It's the part of the starter where the wires are bolted on. You'll have to remove and rebuild the starter.

User Avatar

On my 98 buick LeSabre the fuel filter was under the car passenger side just in front of the rear tire.Good luck!

User Avatar

there is 3 wires to the starter disconnect them. Then remove the mounting bolts and detach the starter the reverse to installation

User Avatar

The license plate bulb on a 1998 Buick LeSabre is replaced by removing the retaining screws and disconnecting the wiring harness. The bulb can then be twisted from the socket and a new bulb installed.

User Avatar

There are 2 bolts that hold it to the rear of the engine.

User Avatar

under the front of the engine about center of the engine. hope this helps

User Avatar

If you lights do not dim when turning key, then probably your starter.

User Avatar

Disconnect the - battery cable Raise and support vehicle Disconnect wiring at the top of starter Remove starter mounting bolts Remove starter


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.