Is it gasoline or diesel? If it is diesel, it is in the passenger side of the motor up by where the transmission mounts. It is held by three screws which can be a little tricky to get in and out since it is in a rather cramped space. It took me a little over an hour to change mine out. Since I do not have the gasoline engine, I can't say for sure about where the starter is on that make, but I would figure it would be in around the same location close to the flywheel.
No because they are 2 compleatly diffrent body styles
There are five models of the Ford f350 Dually. These models were released consecutively each year by Ford company. Each of them has different specifications.
only if the f250 is a dually to but otherwise no because the front and rear wheels are offset on the dually
Your answer is NO... The F550 & F450 use a 10 bolt patern and the F250 & F350 use an 8 bolt patern.
A 2002 f350 drw is 7.5 feet wide.
The towing capacity of a 2001 Ford F350 dually diesel 4x4 truck is 8,250 pounds. This allows the truck to safely transport all but the largest trailers and boats.
no. a f350 bolt pattern is not the same to a f-450 bolt pattern because the f350 have 8 lug nuts and the f450 has 10 lug nuts
Ford F350 Super Duty Dually
The Ford F350 is a full-sized, super duty truck. It is available with single rear wheels or as a dually. For more information, visit http://www.carsdirect.com/ford/f350.
original sticker price for a ford f350 1994 dually xlt
Answering "What is the wheel bearing torque specs in ftlbs on a Ford 10.5 rear axle on a 2002 F350 Super Duty 4x4 non dually diesel?"
they are aproxametly 7,000 pounds depending on how they are equiped
My crew cab long bed 4x4 dually with in bed tool box and 55 gal main tank weighs in right at 7500lbs
No, the 2003 Ford F350 rims will not fit on a 1999 Ford F350.
Yes, the rims off a 2002 Ford F350 will indeed fir on a 1999 Ford F350.
Depends on the year but most are located under the hood on the drivers side and under the dash on the drivers side as well.
Mine is getting 10ish without the overdrive engaging, so I'd guess it would do better with overdrive.
autozone repair!!! www.autozone.com
First disconnect your batteries then mark all wires on starter so you know where they go on the new starter. Then remove three bolts and bam do this in reverse order and your done!
The 1992 Ford Taurus starter solenoid is bolted onto the side of the starter itself. The starter is at the rear of the engine at the bell housing.
According to AllData, the toe alignment specs are 0.03 degrees +- 0.25 degrees, which essentially means zero degrees (no toe-in or toe-out).
On the top side (the side closest to the truck bed) of the rear differential. I replaced it on my 2wd dually in less than 10 minutes.