Car Computers and Sensors
Antifreeze and Engine Coolant
Ford Expedition Eddie Bauer
Ford F-150

Where is the the coolant temperature sensor on a 2000 Ford F-150 5.4 V8 4wd?

101112

Top Answer
User Avatar
Wiki User
Answered
2009-03-21 20:53:29
2009-03-21 20:53:29

IT IS LOCATED ON THE INTAKE Because ECT (engine coolant temperature) sensor procedures vary depending upon their location, first locate the part. You may need to partially drain the engine coolant to prevent coolant spillage. * Disconnect the negative battery cable. * Unplug the ECT. * Then, unscrew it. * Reverse the removal procedures to install the new part. * Connect the negative battery cable to the battery.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


Te 2000 F150 does not use a coolant temperature sensor. The engine uses a cylinder head sensor close to the head back to check the temperature.

where is the CHT sensor on a 2000 ford F150 where is the CHT sensor on a 2000 ford F150

The 1999 F150 4.2 does not have a temperature sensor. It uses a cylinder head temperature sensor instead. It is mounted at the rear of the engine on the head.

One the engine block on the 302 and 351's

on the side of the block not the one buy the oil filter

should be located by the thermostat housing on front of engine block

The coolant temperature sensor on a 1989 Ford I6 4.9L engine is located on top of the engine, in the intake manifold. It notifies the engine when to turn on the cooling fan.

where is the coolant sensor located at on a 05 ford f150 with a 5.4 triton v8

Could be low coolant level, faulty thermostat, or faulty temperature sensor. Check coolant first.

Temperature Gauge Sending Unit The sending unit is located in the front section of the intake manifold in the vicinity of the thermostat.

Temperature Gauge Sending Unit The sending unit is located in the front section of the intake manifold in the vicinity of the thermostat.

The temperature gauge sensor on the 2002 F150 is located on the driver's side of the vehicle and under the intake. This is almost impossible to remove without removing the intake itself.

ford speed sensor are usually in the differential housing.

The temperature gauge should be connected to the transmission temperature sensor. The transmission temperature sensor is located on the right-hand side of the transmission.

Code PO125: Insufficient coolant temp for closed loop fuel control. This means that the voltage from the temperature sensor is lower than expected, and is being ignored. The fuel management system stays at default settings similar to a cold start. The oxygen sensor is not being used to adjust the fuel mix and the fuel mix will likely be on the rich side. Also, depending on the system, the intake air pre-heater may stay on. Causes: 1. Coolant temperature too low, engine does not come up to temperature; Thermostat stuck open, or missing. 2. Temperature sensor failed. If your engine appears to be warming up ok, then it is likely the temperature sensor. Typically, coolant temperature sensors may fail within 4 to 5 years. Your engine may have 2 temperature sensors: one for the fan, and another for the fuel management system. Consult a repair manual.

The sensor can be checked for resistance with an ohm meter. The sensor can be checked while cold then hot for resistance change.

Look just in front of the radiator on the driver's side.

The thread on cap on your engine coolant reservoir is your pressure cap / radiator cap

Put a new egr electrical position sensor on and a new coolant temp sensor and fill the radiator with coolant. This will fix all but the check engine lite.

Coolant temperature sending unit is located on the front of the engine. The cooling temperature sending unit will be on the right hand side of the engine.

If you cant find your 2000 F150 4.2 V6 Temp. gauge sensor on the intake manifold, try looking underneath the engine. Back of driver side cyl. head that's where I found mine sensor was broken off. Jumper this connection turn key to on position, if gauge goes replace sensor.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.