follow your big hose at the end of your ratiator that goes to your motor where the hose meets the motor is the thermostate its 2 bolts that you need deep well socots for and the computer chip is located inside the computer under your hood
Follow the upper radiator hose back to the engine, it is connected to the thermostat housing on the engine. The thermostat is located under the thermostat housing.
follow the top radiator hose to the engine. It should be there.
It will be to the left of the thermostat housing, in the intake.
Check the engine thermostat. Its probably stuck open.
follow the upper radiator hose to the thermostat housing on engine. Thermostat is located under the thermostat housing.
Follow the upper radiator hose from the radiator to the engine. It is attached to the thermostat housing. Removing the thermostat housing will expose the thermostat.
I hope this question is about the engine coolant thermostat. If it is and you have to ask this, you shouldn't be allowed near a vehicle with a tool.
The thermostat is located in the housing that the top radiator hose connects to, the bolts holding it on to the engine are metric.
Follow the top radiator hose down to the water outlet on the engine. The stat is in there.
Up front, on top of the engine, next to the thermostat housing.
The thermostat is inside the small housing where the top radiator hose connects to the engine block.
Factory said to use a 195 degree thermostat
It is important that the spring end of the thermostat is facing into the engine when installed.
Follow the upper radiator hose from the radiator to the engine. It will lead you to the thermostat housing. Drain coolant from radiator, remove upper radiator hose from engine, remove the two bolts holding the thermostat housing to engine, remove housing, remove thermostat.
Assuming this is a 4.3L engine the ect (engine coolant temp sensor) would be located next to the thermostat housing.
The temp sensor for the ECM (engine control module) is next to the thermostat housing.
It has a Manual thermostat. The thermostat is normally located where the upper radiator hose connects to the engine. Look Carefully at this location.
located on the intake manifold just follow the upper radiator hose to the engine should be 2 bolts holding the thermostat housing down.
Yes it will, but you have to put all the blazer engine stuff onto the beretta engine...
How do you reset check engine light for the 2009 Chevy trail blazer?
wat other motor can i put in my 2001 chevy blazer