The thermostat, on your 1992 Mazda, can be found on the front bottom portion of the engine. You can follow the water hose from the bottom of the radiator to the thermostat.
What is a timing cover seal on a 1992 mazda 929 and where is it located at?
its located in the rear towards the drivers side
The thermostat on a 1993 Mazda 929 is located on the top of the motor just before the manifold covers. Look for the largest hose coming from the radiator at the top and trace the length of the hose back to its connection to the motor and the thermostat is at the point the hose connects to the motor.
The Thermostat is located at the low side radiator hole housing ( one end of the hole is connect from the radiator and the other end is connect to the housing
On most cars the thermostat is on the top hose, but not this one. Find the bottom large hose and trace it up, there you will find three bolts to remove the lower cup that holds the thermostat. Be carfull because the uperhose has water in it, and your working right below it.
1992 Mazda 929
Over driver's side rear tire. It's located on the right under side of the engine and easy to get to.
Underneath each side of the exhaust manifolds.
The 1994 Mazda 929 dryer receiver is located on the firewall in the engine compartment. The dryer receiver will be on the passenger side of the firewall.
BECAUSE ITS DOING ITS JOB!!!!!!!!!!!!!.whats your next question. why does my Mazda have doors?
Hi Its located under the timing belt cover......better plan on replacing the timing bet too
could be water pump or radiator or radiator cap try that if that don't work than you had to do something wrong on the head gaskets
929 1990 Mazda power brakes fails
WHATS THE TIMING MARKS ON 93 MAZDA 929
on the passenger side, its mounted on the transmission cant miss it
To adjust the idle on Mazda 929 from 1992-1995.......on the top side off throttle body there is a idle air screw,turn screw cloclwise to reduce RPM. Question...is idle always high when hot or cold?
open the cover and read it
you have to remove the dash and every thing attached to it. Is it the same for a 1988 Mazda 929?
The Exhaust Gas Recirculation valve (EGR) is located on the rear of the intake manifoldup against the firewall and below the Dynamic Chamber. It is virtually impossible to access without removal of the dynamic chamber.
originalkeyless.com they have the remote and the programming for Mazda 929's
The right side will have a burnt out/ missing light bulb.
In Canada traction control was optional on the 929.
under the car i have a 94 in it got rust in the tank ima clean it out