answersLogoWhite
Thermostats
Chrysler Sebring

Where is the thermostat located on a 1996 Chrysler Sebring Convertible JXI 2.5L 6 cylinder?


Top Answer
User Avatar
Wiki User
2015-07-17 17:52:07
2015-07-17 17:52:07

The engine thermostat is located in a thermostat housing, located below the throttle body.

REMOVAL

  1. Drain cooling system to the thermostat level or below.
  2. Remove inlet hose and coolant elbow from thermostat housing.
  3. Remove thermostat assembly, and clean sealing surfaces.

INSTALLATION

  1. Install thermostat into the recess in the thermostat housing.
  2. Install inlet elbow and tighten the bolts to 12 Nm (133 inch lbs ) .
  3. Fill cooling system.

standing on the drivers side, looking at the engine, it's under the radiator cap housing. there are (if i remember correctly) three bolts (10MM?) not very easy to get your hand/tools down in there. it's not that bad to replace, just tedious.

Related Questions

User Avatar

On a Chrysler Sebring 2.5L the thermostat is under the housing where the lower radiator hose hooks to the engine.

User Avatar

Four cylinder, it is where the upper radiator hose attaches to the engine. Six cylinder, it is where the lower radiator hose attaches to the engine.

User Avatar

On the four cylinder it is under the housing where the upper radiator hose attaches. On the six cylinder it is under the housing where the lower radiator hose attaches.

User Avatar

four cylinder, under the housing where the upper radiator hose attaches. Six cylinder, under the housing where the lower radiator hose attaches.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.