TRICKY!!!!! !!!!
The thermostat is located on top of the engine. (NOTE there is a AIR BLEED VALVE on the alum housing). The large radiator hose leads right to the housing. Remove two screws and lift off the alum housing along with the hose. thermostat can be lifted out. Replace and be sure you use sealer+ new gasket when reconnecting hose and housing.
The problem is that the system will have air trapped in the system and not cool engine properly. You have to attach a pressure pump to the top of the overflow container after everything is installed . Open bleed valve , apply pressure until water comes out then close bleed valve. disconnect pressure pump and replace pressure cap on reservoir.. Re-do the operation after running the engine a few minutes to see if trapped air remains.
Refer to your user and service manual to see how you can remove a radiator from a 1995 Chrysler New Yorker.
Low coolant, failed water pump, restricted radiator, inoperative radiator fan, thermostat,
Chrysler dealer,
Location for sigil start for a 95.chrysler new
The thermostat is under the housing where the upper radiator hose attaches to the engine.
The thermostat is located under the housing where the upper radiator hose hooks to the engine.
Chrysler does not use reset switches.
It doesn't have one.
It is under the housing where the upper radiator hose hooks to the engine.
below thermostat housing little to left
It is under the housing where the upper radiator hose attaches to the engine.
Chrysler New Yorker was created in 1939.