answersLogoWhite

0


Best Answer

the way it looks in the chilton manual, the timing marks are on the crankshaft and the intermediate shaft sprockets. If anything else is found, it will be posted. hope this is of some help to you for now.

User Avatar

Wiki User

โˆ™ 2008-01-03 00:02:20
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +20 pts
Q: Where is the timing mark on a 1994 Caravan 2.5L 4-cylinder?
Write your answer...
Submit
Related questions

Were is the timing mark an a 1994 Nissan Sentra 1.6l?

Were is the timing mark an a 1994 Nissan sentra 1.6l?


Where is the timing mark for Plymouth acclaim 1994 2.5 liter?

where is the timing mark for Plymouth acclaim 1994 2.5 liter?


On a 1994 ford aerostar how do you reach the timing mark with a timing gun with the pulleys in the way?

get at it from the bottom get a white marker and mark the timing spot then go up top and you should be able to see it


How do you install a new timing belt on a 1993 Mazda 626 4cylinder and where is the timing mark on it?

Again I stress it out highly, if you are doing this job yourself, you need tools and a good shop manual on your car and yr. The manual will explain lots of things to do on this job.


When timing the timing belt do you use the mark for top dead center on the crank or the mark on the oil pump next to the crank I have a Nov 1994 date of manufacturing 3.2 Isuzu Rodeo?

When timing the timing belt you use the mark for top dead center on the crank. To do that you will have to do a few different steps.


What are the timing mark setting on a 2001 Mitsubishi Galant 2.4L?

2.4l dohc balance shaft timing mark, crankshaft sprocket timing mark,oil pump timing mark and camshaft TWO timing marks 2.4l sohc balance shft timing mark, crankshaft timing mark, oil pump timing mark and ONE camshaft timing mark. it is complicated only that everymark must be bang on, if not the pistons will hit the valves and YOU get to rebuild engine.


Where is the timing mark location on a 1987 motor Chevy 350?

there will be a timing mark on the harmonic balancer. and a timing tab on the timing chain cover. point your timing light at the timing tab and you should see the timing mark on balancer. if not timing is way out.markstang.


Set timing on dodge caravan 1998?

Connect a timing light to the car battery. Attach the clamps to the number 1 spark plug and shine the timing light on the pulley connected to the crankshaft. Note where the timing mark on the pulley is compared to the degree tab. Loosen the distributor lock-down bolt at the base of the housing and disconnect the hose. Rotate the distributor with your hand until the timing mark aligns at 12 degrees.


How does one find the timing marks for a '95 S-10 - 2 point 2 liter engine?

ON MY 2.2 4CYLINDER ( 1999 ) YOU HAVE TO PULL THE TIMING CHAIN COVER TO SEE THE " TIMING MARKS " . ON THE CRANK SPROCKET IT IS A PUNCH MARK.....ON THE CAM SPROCKET IT IS A SMALL HOLE IN THE SPROCKET . BOTH MUST LINE UP WITH TABS ON THE CHAIN TENSIONER. THE REST OF THE TIMING IS DONE BY CRANK & CAM SENSORS AND THE COMPUTER.


Knock sensor location 1994 mark 8?

The knock sensor on a 1994 Lincoln Mark 8 is located on top of the engine, near the upper radiator hose. It constantly monitors for the distinctive knock made from incorrect ignition timing.


Where is the timing mark on the crank shaft for a 1994 Chevy 350?

it is located on the harmonic balancer outer edge even with the crankshft "key"


Citroen relay timing marks?

timing mark


What is the timing mark for a 1974 dodge dart 318?

The timing mark is a line that goes across the harmonic balancer that should line up with the mark on the timing chain cover. It is on the drivers side on the bottom of the timing cover.


What are the timing marks and how are they lined up on a 1994 Geo Metro 3 cylinder?

on the balencer there is a timing mark and om the motor theres a tab there is also a mark on the cam gear, when lined up, both marks on the crank gear and cam gear point up.


Where is the timing mark on a Chevy 1500 with a 350?

The timing mark is one the Harmonic balancer and the pointer is attached to the timing cover. Roll the motor over to the timing mark, the be sure and mark the number one plug {marked on the intake manifold} the position of the rotor pointer on the distributer.


If there is no timing mark on the timing cover of a 350 how can you set timing?

you can purchase an aftermarket timing tab which bolts to the timing cover.


Where is the timing mark supposed to be pointing on the cam when a timing belt is put on a 1993 dodge caravan?

You have 3 engines. I assume you have the largest. This is weird. There is a paint color on the new chain that mates a dot on the cam gear and a color that matches a dot on the crank shaft gear.


Where fuel pam timing mark scania 400?

The fuel pam timing mark Scania 400 is on the engine.


How do you line up the timing marks on a 3406E Cat engine?

pin the engine on the flywheel. line the timing mark on the cam gear with the timing mark located on the timing cover. the mark on the cover is located at the top and is just a bump formed in the cover.


1990 camaro rs v6 and you had replaced the distributor and messed up the timing how can you fix it?

well first you need to get the timing close enough to crank then put a timing light on it and bring timing to top dead center.. which is the second mark on the timing chain cover.. there will be a mark on the harmonic balancer line that mark up with the second mark on the gauge on the timing chain cover.. and should be fine


Distributor on 283 Chevy?

30 degrees dwell, timing is the second mark above the O mark on the timing tab.


Where are the timing marks on your 2000 ford focus lx?

The top timing mark is a notch on the head. It lines up with an arrow on one of the O's cut out in the timing gear. The bottom timing mark is on the crankshaft gear and it lines up with a mark on the oil pump housing.


Where is the crankshaft sensor located on a 1996 ford ranger 4cylinder?

its on the front behind the front cover to replace it you need to take off the fan the a/c compressor and its bracket dont take off the lines to the compressor just unbolt it and move it out of your way to get enough access to thi timing system you have to take the timing belt off so mark on the pully to align it after you are done


Where are the timing marks on a 1997 suzuki esteem?

The timing marks on a 1997 Suzuki Esteem is on the crankshaft pulley. The crank mark needs to line up with the ignition timing mark.


What is the timing mark for 1990 Honda accord?

there are two kinds of timing marks. one is for ignition timing and one for valve timing.