It is next to the transfer case solonoid located underneath the damp control spectrometer.
The 1998 Chevrolet K2500 Suburban is able to tow up to 6,000 pounds. Standard features include power steering, and tinted glass.
NO not even close. You must stay under the year of 1999
it should be right on top the motor
The 1993 K2500, 4wd with a 7.4L engine has a 42 gallon tank.
According to IntelliChoice (see links), the curb weight of a 1991 Chevrolet Suburban K2500 is 4,540 pounds. The gross vehicle weight is 8,600 lbs.
The C2500 is 2wd and k2500 is 4wd.
Just changed mine today in a 99 GMC K2500 Suburban 4WD and it took 3 quarts
The wires going into the AC pump 1995 Chevy K2500 are the red-marked wires.
The 1998 K2500 Suburban has a 44 gallon gas tank.
Per GM this vehicle tow rate is 9,500 lbs.
On the front axle, passengers side of carrier housing.
The rated horsepower of a 1999 K2500 Chevy truck is 255. The base engine is a V-8 that is 5.7 cubic liters.
It is bolted in the transfur case tail shaft housing with 1 bolt and has an electric wire connected to it.
If it has a bank two, It would be on the passenger side. I have a 1994 K2500, it only has one oxygen sensor.
Yes these engines can be swapped because they are both fuel injected engines and should be very close if not identical.
The gross weight of a 1988 Chevy Silverado K2500 with a 5.01 engine is about 2.5 tons. This is equal to about 5,000 pounds.
Need to know what year and model the truck is. 1992 Chevy k2500
It does not have a reset switch. It does have a relay and a fuse that controll function.
It is 8,600 standard, or 9,100 maximum. Lbs
my 97 gmc suburban k2500 454 takes 7 qts of oil during oil change.
Check the manifold, just before the headpipe.
Its on the front of the crankshaft in front of the timing chain.
how do you change a pump water on a 2004 Chevy truck k2500 hd
Most likely it's Dextron III automatic transmission fluid. Might want to check the Amsoil site - they might have a look-up.
Disassemble the dash, open up the HVAC compartment.