Ford Ranger XLT

Where is the transmission dipstick in a 1988 ford ranger 2.9 liter V6 4x4?


Top Answer
User Avatar
Wiki User
2008-05-12 02:28:33
2008-05-12 02:28:33

Looking from the front of the engine I believe it should be at the back of the engine by the firewall , just to the left of the engine for your automatic transmission dipstick

User Avatar

Related Questions

The manual transmission doesn't have a dipstick , there will be a fill plug on the transmission

The dipstick is on the lower front of the transmission on a LeBaron.

In a 1988 Ford Ranger : With the 2.9 liter V6 engine , 4X4 : It has the Mitsubishi FM146 5 speed manual transmission ( transmission code " D " ) that takes ( 2.4 U.S. quarts of 80-90W gear lube )

The transmission dipstick on a 1988 Ford F-150 is on the drivers side of the engine bay. This will be back towards the firewall.

buy a chilton it explains, no dipstick on the manuals. speedometer cable is the dipstick

The slave cylinder for a manual transmission hydraulic clutch is inside the manual transmission bellhousing

Fluid is added through the transmission dipstick.

For a 1988 Ford Ranger : M5OD-R1 , 5 speed manual transmission ( transmission code " M " ) 2.9 liter V6 engine , rear wheel drive ( 2.8 U.S. quarts of MERCON automatic transmission fluid is used )

The 2.0 liter 4 cylinder , the 2.3 liter 4 cylinder , or the 2.9 liter V6

should be a dipstick back next to the firewall for checking transmission fluid.

from the transmission dipstick use some adaptor so you can drop your oild inside.

If your car has an automatic transmission, there will be a short dipstick near the front (radiator side) of the transmission. With the transmission warmed up (go for a short drive), park on a level surface, and with the transmission in park or neutral and engine running, pull the dipstick out and check the fluid level against the markings on the dipstick.

The transmission dipstick is located on the passengers side rear. Near the firewall / or back of the engine. The dipstick is color yellow or red.

I believe the 2.9 liter V6 engine in a 1988 Ford Ranger is rated at : ( 140 horsepower )

Down the tube that holds trans dipstick.

transmission fluid is uaually added through the trans dipstick tube.

If that is an automatic transmission, pull the dipstick and read it, it will tell what fluid to use.

Through the automatic transmission fluid level dipstick , near the firewall

Yes... where the dipstick is. You take a funnel and add enough fluid to fill it up to the proper level. Do this while the engine is running and the transmission is in Park.

yes they are the same transmission, does not matter if the engine is a d15 1.5 liter or a d16 1.6 liter

Use a small hose or funnel and put it in the dipstick hole

simply pour the fluid down th dipstick hole........

through the tranny dipstick tube with a tranny funnel.

Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.