located by the glove box, close to the fuse box as well. There are 2 flashers. I read many different tips, but finally found my turn signal flasher right on top of the ash tray assembly. Take out ashtray. Remove 4 small hex head screws to remove the assembly that the ashtray slides in to. I found the turn signal flasher in a clip on the top side of that assembly. The hazard flasher was to the outside of the glove compartment. You have to remove the glove box. You will see a wiring harness on the outboard side, right above the light that lights the area where the passenger's feet are. The flasher is plugged in on the side that you cannot see. You will never know it is there, if it is not working and "ticking." Best way to look for it is probably with a "mirror on a stick." Good luck hope this saves you having to disassemble your entire dash, like me...
Where is the choke sensor on a 1991 Oldsmobile ciera 3.3L
the way your mom gets on her knee
my car turn over,but will nostart.
the crank sensor is behind the harmonic balancer
how do ypu change front turn signal bulb on Oldsmobile 1991 cutlass cierra
The ECM is located behind the glovebox on a 1991 Cutlass Ciera. Pull the glove box out to see it. Once located remove the mounting hardware and unplug it from the car. Replace the unit.
Need to know what quad drivers are...
No they are not. The hazard flasher should be located in the fuse panal. While the turn signal flasher is located behind the dash near the AC controls. Can be a pain to find and replace.
The turn signal flasher is next to the fuse panel at the lower left of the steering column. The hazard flasher is located to the right of the steering column.
The 1991 Pontiac turn signal flasher relay switch can be found beneath the drivers side dashboard. The turn signal flasher relay switch will be above the gas pedal.
This probably has to be ordered from the dealership as it needs to be encoded, which is proprietary information.
My 1991 Olds Cutlass Ciera had that problem and it was corrected by replacing the turn signal switch. Troubleshooting with the factory service manual pinpointed the problem. Paul S