Ford Expedition

Where is the vacuum shift motor located on a 1998 Ford Expedition 4 wheel drive with the 5.4 V8?

141516

Top Answer
User Avatar
Wiki User
2005-10-17 14:29:53
2005-10-17 14:29:53

Underneath the the plastic cover on the front differential.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

The electric shift motor is located on the rear of the transfer case. Attached by 4 bolts and a wiring harness.

User Avatar

vacume lines to 4weel drive unit are located on left sie fender under the hood right side if facing motor

User Avatar

There is a shift fork that is engaged using vacuum from the motor. The shift fork is located inside the front axle more towards the passenger side. When you engage four wheel drive it lets the vacuum go down to a motor that moves the fork to lock the hubs

User Avatar

The vacuum diagram is on a sticker located on the hood underside or on the front radiator support cover

User Avatar

The differential is part of the transmission gear train. It does not have a separate motor.

User Avatar

The encoder motor is located on the transfer case. The transfer case is on the driver's side of the truck. It resides between the front drive line, and the wall of the transfer case.

User Avatar

Its located on the passengers side of the vehicle under the dash right next to the recirculating vent and the vacuum motor...........

User Avatar

Where is the blower motor relay at.

User Avatar

This is ussually located on back side of the motor facing the firewall, and closer to the intake than the bottom of motor. Also, you should have some type of vaccumm line running to it as well. Follow your vacuum lines to that side of motor.

User Avatar

it is so important because with out a motor driven vacuum it would be harder to vacuum clean also how would you clean without a vacuum cuz using a broom is hard

User Avatar

Diagrams are usually located on a sticker under the hood. If not, get a motor manual with vacuum diagrams in it.

User Avatar

It is located on the transfer case this is the motor that shifts your four wheel drive

User Avatar

Any tansfercase motor is to switch from 2 wheel drive to 4 wheel drive. It is located behide the transfer case and it has 6-7 wire plug. Only automatic push button 4 wheel drive trucks have the transfer case motor.

User Avatar

Sounds like your problem is the brake booster valve ...... When the valve goes bad it takes the vacuum away from the motor, and when you apply the brake the motor will stutter and when you pull it into gear it will usually kill the motor unless you are giving it a little more gas than you normally would to keep the motor running. The little valve is located at the booster...it will have a small vacuum hose that comes from the motor to the brake booster valve. The valve just pops into the booster, and can be found at some auto parts store.

User Avatar

The motor in a vacuum cleaner is an electromagnetic device.

User Avatar

The vacuum hose located near the firewall behind the battery. About the size of a straw as I was told by dealer. vacuum contol motor or a broken switching cable

User Avatar

You get to the rear air fan motor in a 2004 Ford Expedition by removing the bottom of the glove box. You will then see the motor housing, and a clip that you must remove to get to it.

User Avatar

Its under the dash on the passenger side of the truck. juat a few screws very very easy

User Avatar

It is possible to use that kind of motor, but it's also possible to use other types, like an AC motor. Also, i wouldn't suggest using it because of the high cost.

User Avatar

The water pump on a 1997 Honda Accord is attached to the 2.2 VTEC motor. The water pump is located underneath the pulleys of the drive belt of the motor.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.